SIGMA BC 10.0 WL STS Cycling Computer Instruction Manual
- June 4, 2024
- SIGMA
Table of Contents
SIGMA BC 10.0 WL STS Cycling Computer
CONTENTS
TECHNICAL DATA
- Computer WIRED:
- Battery type: CR 2032, 3V
- Battery life: 3 years (When used for 1 hour per day)
- Computer WIRELESS:
- Battery type: CR 2032, 3V
- Battery life: 2 years (When used for 1 hour per day)
- Transmitter:
- Battery type: CR 2032, 3V
- Battery life: 1.5 years (When used for 1 hour per day)
INSTALLATION
INSTALLATION MOUNT
FIRST START
Battery already installed.
INSTALLATION WIRED SPEED SENSOR
INSTALLATION OF WIRELESS SPEED TRANSMITTER
Emission frequency: 112 kHz, Max power < 11.37 dBm
FUNCTIONS / SETTINGS
BUTTON OVERVIEW
DISPLAY OVERVIEW
MENU BASIC BIKE FUNCTIONS
SETTINGS MENU
EXAMPLE OF SETTING PROCEDURE:
-
Open settings: Press and hold S button >3 sec. until settings open.
-
Choose the relevant page: Press M button until desired value is displayed.
-
Open submenu: Press 1x S button.
-
Change value: Press M button until desired value is displayed.
-
Confirm choosen value: Press 1x S button.
Note: Do steps No. 4 and No. 5 until the submenu is closed „Set Ok“. You are now back in the Settings Menu. -
Close settings: Press and hold S button >3 sec.
BATTERY CHANGE
BC 10.0 WR/WL
SPEED TRANSMITTER (BC 10.0 WL)
LEGAL STATEMENTS
FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT
Caution: If any changes or modifi cations not expressly approved by the
party responsible for compliance could void the user’s authority to operate
the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
The grantee is not responsible for any changes or modifi cations not expressly
approved by the party responsible for compliance. Such modifi cations could
void the user’s authority to operate the equipment. The RF Exposure Compliance
distance is 5 millimeters.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and
can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC ID ATS2021: M5LATS2021
INDUSTRY CANADA STATEMENT
This device complies with Innovation, Science and Economic Development Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may
cause undesired operation of the device.
CAN ICES-3(B)/NMB-3(B)
The device meets the exemption from the routine evaluation limits in section
2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can obtain
Canadian information on RF exposure and compliance. This transmitter must not
be co-located or operating in conjunction with any other antenna or
transmitter. This equipment should be installed and operated with a minimum
distance of 5 millimeters between the radiator and your body.
UKCA STATEMENT
Wireless Model
We, SIGMA-ELEKTRO GmbH, declare that the equipment above has been tested in
our facility and found compliance with the requirement limits of applicable
standards, in accordance with the Radio Equipment
Regulations 2017 and the Restriction of the Use of Certain Hazardous
Substances in Electrical and Electronic Equipment Regulations 2012. The test
record, data evaluation and Equipment Under Test (EUT) confi gurations
represented herein are true and accurate under the standards herein specifi ed.
Wired Model
We, SIGMA-ELEKTRO GmbH, declare that the equipment above has been tested in
our facility and found compliance with the requirement limits of applicable
standards, in accordance with the Electromagnetic Compatibility Regulations
2016 and the Restriction of the Use of Certain Hazardous Substances in
Electrical and Electronic Equipment Regulations 2012. The test record, data
evaluation and Equipment Under Test (EUT) confi gurations represented herein
are true and accurate under the standards herein specified.
EU-DECLARATION OF CONFORMITY
We, SIGMA-ELEKTRO GmbH, Dr.-Julius-Leber-Str. 15, D-67433 Neustadt/Weinstraße
declare under our responsibility that the product BC 8.0 WR are compliant with
the essential requirements of the EMC Directive 2014/30/EU and the RoHS
Directive 2011/65/EU. The declaration of conformity can be found at:
ce.sigmasport.com/bc80wr
We, SIGMA-ELEKTRO GmbH, Dr.-Julius-Leber-Str. 15, D-67433 Neustadt/Weinstraße
declare under our responsibility that the product BC 8.0 WL and the
transmitter ATS2021 are compliant with the essential requirements and other
relevant requirements of the RED Directive 2014/53/EU and the RoHS Directive
2011/65/EU. The declaration of conformity can be found at:
ce.sigmasport.com/bc80wl
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>