Artwork CIVIC Type-R FK8 17-21 Front Splitter Instruction Manual
- June 9, 2024
- Artwork
Table of Contents
Artwork CIVIC Type-R FK8 17-21 Front Splitter
INSTALLATION INSTRUCTIONS
- Jack the front of the car for easy access (don’t forget to put your jack stands).
- Align perfectly the lip under the bumper (the tip of the lip should be lined with the corner of your bumper near the wheel, see picture above).
- With the permanent marker, mark the drill spot on the bumper through the holes of the lip (the lip should not move if you can’t reach the bumper with your marker, skip to step #4).
- Drill in the middle of your marks (or holes) with a 5/16 drill bit.
- Make easy access to reach the holes inside the bumper. assemble the lip with hardware (see assembly instructions).
- Put the lip on the bumper by aligning the bolts through the holes and adding the lock nuts over the bolts inside the bumper.
- Tight the bolts by the bottom of the splitter with your hex key.
- Reinstall all removed trims and you’re ready to rock n roll. take pictures and send them to info@artworkbodyshop.com and don’t forget to tag us on social media @artworkbodyshop.
CAUTION: PROFESSIONAL INSTALLATION IS STRONGLY RECOMMENDED
TOOLS REQUIRED
- CAR JACK & JACK STANDS
- PERMANENT MARKER
- DRILL
- DRILL BITS 5/16
- HARDWARE BAG (INCLUDED)
- TORX, PHILLIPS, 10MM BOX (TO REMOVE YOUR SPLASH GUARD, IF NECESSARY)
ASSEMBLY INSTRUCTIONS
PARTS LIST
- INSTALL YOUR BOLT WITH YOUR HEX KEY BY THE BOTTOM OF YOUR LIP
- 3/8″ Round Spacers
- 1/2″ Round Spacers
YOUR LOYALTY AS A CUSTOMER IS GREATLY APPRECIATED
© 2022 ARTWORK BODYSHOP
CIVIC TYPE-R FK8 17-21
FRONT SPLITTER
IF YOU ARE HAVING ANY QUESTIONS PLEASE EMAIL US AT INFO
@ARTWORKBODYSHOP.COM
ARTWORKBODYSHOP.COM
References
Read User Manual Online (PDF format)
Loading......