Artwork Acura TLX 2015-2017 Front Splitter Instruction Manual
- October 30, 2023
- Artwork
Table of Contents
TLX 2015-2017 Front Splitter
Instruction Manual
ASSEMBLY INSTRUCTIONS
ACURA TLX 15-17 • FRONT SPLITTER
BASE MODEL
SPACERS SIDE VIEW
PARTS LIST MAY DIFFER ACCORDING TO YOUR MODEL
PARTS LIST
| 50mm M8 Bolts x 2
25mm M8 Bolts x 2
---|---
| M8 Lock Nuts x 4
| 1/4″ Round Spacers x 2
| 1-1/2″ Spacers x 2
| 30mm M6 Bolts x 2
M6 Finish Washers x 2
| M8 Hex Key x 1
M6 Hex Key x 1
- Install your bolt with your hex key by the bottom of your lip
INSTALLATION INSTRUCTIONS
TOOLS REQUIRED
CAR JACK & JACK STANDS
PERMANENT MARKER
DRILL
DRILL BITS 5/16
HARDWARE BAG (INCLUDED)
TORX, PHILLIPS, 10MM BOX (TO REMOVE YOUR SPLASH GUARD, IF NECESSARY)
CAUTION: PROFESSIONAL INSTALLATION IS STRONGLY RECOMMANDED
- Jack the front of the car for an easy access (don’t forget to put your jack stands).
- Align perfectly the lip under the bumper (the tip of the lip should be lined with the corner of your bumper near the wheel, see picture above).
- With the permanent marker, mark the drill spot on the bumper through the holes of the lip (the lip should not move if you can’t reach the bumper with your marker, skip to step #4).
- Drill in the middle of your marks (or holes) with 5/16 drill bit.
- Make an easy access to reach the holes inside the bumper.
- Assemble the lip with hardware (see assembly instructions).
- Put the lip on the bumper by aligning the bolts through the holes.
- Thight all the remaining hardware inside the bumper (nuts & washers), while holding your hex key into the bolt to make sure it won’t turn.
- Reinstall all removed trims and you’re ready to rock n roll. Take pictures and send them to info@artworkbodyshop.com and don’t forget to tag us on social media @artworkbodyshop.
YOUR LOYALTY AS A CUSTOMER IS GREATLY APPRECIATED
© 2022 ARTWORK BODYSHOP
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>