Artwork Bodyshop VW ATLAS 20-23 Front Splitter Instruction Manual
- June 9, 2024
- Artwork Bodyshop
Table of Contents
Artwork Bodyshop VW ATLAS 20-23 Front Splitter
INSTALLATION INSTRUCTIONS
CAUTION
PROFESSIONAL INSTALLATION IS STRONGLY RECOMMANDED
- Remove each exterior screws under your bumper towards the wheels.
- Align the splitter and install it with the provided phillips screws in the factory holes to hold the splitter in place. (You can use a car jack to hold the middle of the splitter up).
- Use a 3/8″ drill bit and through the remaining holes of the splitter, drill holes under your bumper. Make sure the drill bit stays straight as possible.
- Remove the screws under your bumper so you can access inside the bumper and assemble the splitter with spacers, bolts and nuts like the drawing shows. Screw the nuts inside by hand until it’s tight, and then use the hex key by the bottom of the splitter to tight the bolts.
- Reinstall all removed screws and make sure everything is tight, take pictures and send it to info@artworkbodyshop.com and make sure to tag us on social media @artworkbodyshop !
ASSEMBLY INSTRUCTIONS
| PARTS LIST
---|---
|
| 60mm M6 Bolts x 2
| 30mm M6 Bolts x 2
| 25mm M8 Bolts x 2
| 40mm M8 Bolts x 2
- Install your bolts with your hex key by| | M8 Lock Nuts x 4
the bottom of your lip.| M6 Lock Nuts x 4
|
1/8″ Round Spacers x 2
| | 3/4″ Spacers x 2
1-3/4″ Double Holes Spacers x 2
| #10 x 1″ Black Phillips
Screws x 2| | M6 Hex Key x 1 M8 Hex Key x 1
YOUR LOYALTY AS A CUSTOMER IS GREATLY APPRECIATED – © 2022 ARTWORK BODYSHOP
References
Read User Manual Online (PDF format)
Loading......