TOTO MW6423046CUFGA Nexus Cotton White Elongated Chair Height WaterSense Toilet Instruction Manual

TOTO MW6423046CUFGA Nexus Cotton White Elongated Chair Height WaterSense

Toilet

THANKS FOR CHOOSING TOTO!

The mission of TOTO is to provide the world with healthy, hygienic and more comfortable lifestyles. We design every product with the balance of form and function as a guiding principle. Congratulations on your choice.

COMMON TOOLS NEEDED

• 12” pipe wrench
• 10” adjustable wrench
• Carpenter’s Level
• Tape Measure
• Plier
• Screwdriver
• Putty Knife
• Drill
•  11/64
• 5/16” drill bit for concrete/tile installation

MATERIALS REQUIRED

• Flexible Supply Tube / Connector
• Supply Stop Valve
• Mounting (T) Bolts & Nuts (2pc)
• Wax Ring / Seal

BEFORE INSTALLATION

• Read instruction manual before installation.
• Maintenance and warranty information included in manual, DO NOT DISCARD.
• Locate water supply and drain pipe.

IMPORTANT
incorporated into the toilet drain system. Please contact your builer/contractor for additional information prior to installation.

• Verify enough space is available for installation and unobstructed operation of equipment (doors opening/closing, etc…). Failure to do this beforehand may result in incorrect product installation and possible malfunction.
• Proceed to install the supply hose to the tank and make sure you do not damage the end connection of the hose.
• stallation, verify water and electricity are working properly.
• Thoroughly flush the supply pipes of dirt and debris. Proceed to install the supply hose to the tank and make sure you do not damage the end connection of the hose.
• After installation, verify water and electricity are working properly.
• Gaps between the discharge pipe and the floor should be tilled with mold-resistant silicone-based seal material (Mediseal).
• Minimum required water pressure (tlowing): 7 PSI at 2.64 Gal/min (0.05 MPa at 10 L/min). Maximum water pressure (static): 108 PSI (0.75 MPa).

INCLUDED PARTS AND DIAGRAM

CARE AND CLEANING

WARNING!
DO NOT USE IN-TANK BOWLCLEANERS. The use of high concentration of chlorine or chlorine-related products can seriously by the use of in-tank bowl cleaners.

INSTALLATION PROCEDURE

1. Open the Unifit Rough-In packaging. Follow the Unifit Rough-In Installation instruction.

2. Place the template into position and follow its instructions to prepare for installing the toilet bowl. NOTICE: Do not move the Unitit Rough-In on the Floor Flange after wax seal is set. If this notice is disregarded, discard the wax ring and replace with new wax ring.

3. Place the toilet bowl over the Unifit Rough-In and align the holes on the side of the toilet to the lines marked “A” on the floor.
   NOTICE: Insert the toilet all the way into position. If this notice is disregarded, leakage may result.

4.  Align the toilet perpendicular to the back wall and parallel to side walls; it should not sit crooked or diagonal (ill. 4).

5. Make sure it’s aligned before securing it.

6. Install the side screws to the mounting blocks. Cover the screw head with the provided screw caps (ill. 5).

7. When installing the washlet main unit or standard toilet seat main unit, follow the instructions on the Installation Guide.

8. Once the installation is completed, proceed to verify the toilet unit for leaks.

MAINTENANCE INSTRUCTIONS

Fill Valve Replacement Procedure

1. Shut off the water supply to the toilet.

2. Flush toilet and remove remaining water from tank with a sponge.

3. Remove the water supply connection at the fill valve.

4. Remove old fill valve and use damp sponge to clean inside tank.

5. Place new fill valve inside tank.

6. Thread mounting nut onto fill valve shank and tighten the nut.
   NOTE: Do not over-tighten. Be sure to install fill valve in a position that does not interfere with the trip lever operation.

7. Connect water supply to fill valve shank and hand-tighten only.
   NOTE: Do not overtighten. These are plastic parts. Never use pipe dope on any water supply connection.

8. Attach refill tube to fill valve nipple and clip other end of refill tube to the overflow Pipe.

9. Turn water supply ON and check for leaks outside the tank.

NOTE: As water fills the tank, water is also directed into the overflow tube via the refill tube. This additional flow of water is critical to refilling your toilet’s bowl. Once the water stops filling the tank, some residual drops of water may drip from the fill valve. This is NORMAL as these drops will subside.

ADJUSTING THE WATER LEVEL

Refer to the water level line stamp inside the tank.

1.  The water level adjustment is located in screwdriver to make adjustments:
   • To raise the water level: turn the screwdriver clockwise, or towards the ‘+’ indicator.
   • To lower the water level: turn the screwdriver counter-clockwise, or towards the ‘-’ indicator.
2. Flush after each adjustment to check the water level. When satistied with the water level, flush once more to verity.

SERVICING THE FILL VALVE

NOTE: Due to water conditions in your area, the strainer may r equire periodic clean-ing. An indication that the strainer.

1. Snap off the top cover by pulling from under the tab (see ill. 1).
2. Pinch the tabs of the lever arm to allow its removal (see ill. 2).
3.  Snap off the adjustable rod from the bracket (1) allowing the unit to slide to the bottom and remove the retainer tab by pulling as the arrow indicates (3) (see ill. 3) .
4. Grab hold of the valve unit, twist 1/4 turn counterclockwise and pull the unit out (see ill. 4).
5.  Unscrew nut of the diaphragm housing (see ill. 5).
6. Remove the diaphragm from its housing by carefully pulling the edge of the diaphragm (see ill. 6). Note the position of the diaphragm while removing.
7. Remove the strainer from the tube with needle nose pliers (see ill. 7). Use twisting motion while pulling to help with removal.
8. Rinse all parts under running water to clear any debris, residues or films. Reinstall all parts in reverse order. Turn the water ON and check for leaks and operation.

WARRANTY

1. TOTO warrants its vitreous china products (“Product”) to be free from defects in materials and work-manship during normal use when properly installed and serviced, for a period of one (1) year from date of purchase. This limited warranty is extended only to the ORIGINAL PURCHASER of the Product and is not transferable to any third party, including but not limited to any subsequent purchaser or owner of the Product. This warranty applies only to TOTO Product purchased and installed in North, Central and South America.

2. TOTO’s obligations under this warranty are limited to repair, replacement or other appropriate adjust-ment, at TOTO’s option, of the Product or parts found to be defective in normal use, provided that such Product was properly installed, used and serviced in accordance with instructions. TOTO reserves the right to make such inspections as may be necessary in order to determine the cause of the defect. TOTO will not charge for labor or parts in connection with warranty repairs or replacements. TOTO is not responsible for the cost of removal, return and/or reinstallation of the Product.

3. This warranty does not apply to the tollowing items:

   • Damage or loss sustained in a natural calamity such as fire, earthquake, flood, thunder, electrical storm, etc.

   • Damage or loss resulting trom any accident, unreasonable use, misuse, abuse, negligence, or improper care, cleaning, or maintenance of the Product.

   • Damage or loss resulting trom sediments or toreign matter contained in a water system.

   • Damage or loss resulting trom improper installation or trom installation of the Product in a harsh and/or hazardous environment, or improper removal, repair or moditication ot the Product.
     (NOTE: Product model codes allow a maximum of 80 PSI. Check local codes or standards for requirements).

   • Damage or loss resulting trom electrical surges or lightning strikes or other acts which are not the
     fault of TOTO or which the Product is not specified to tolerate.

   • Damage or loss resulting trom normal and customary wear and tear, such as gloss reduction, Scratching or tading over time due to use, cleaning practices or water or atmospheric conditions.

   • Tank tlushing mechanisms of plastic or rubber moving parts.

   • Toilet seats ot plastic, wood or metal.

4. In order for this limited warranty to be valid, proof of purchase is required. TOTO encourages war-ranty registration upon purchase to create a record of Product ownership at http://www.totousa.com. Product registration is completely voluntary and failure to register will not diminish your limited war-ranty rights.

5. THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY HAVE OTHER RIGHTS WHICH VARY FROM STATE TO STATE, PROVINCE TO PROVINCE OR COUNTRY TO COUNTRY.

6. To obtain warranty repair service under this warranty, you must take the Product or deliver it prepaid to a TOTO service facility together with proof of purchase (original sales receipt) and a letter stating the problem, or contact a TOTO distributor or products service contractor, or write directly to TOTO U.S.A., INC., 1155 Southern Road, Morrow, GA 30260 (678) 466-1300 or (888) 295-8134, if outside the U.S.A. If, because of the size of the Product or nature of the defect, the Product cannot be returned to TOTO, receipt by TOTO of written notice of the defect together with proof of purchase (original sales receipt) shall constitute delivery. In such case, TOTO may choose to repair the Product at the purchaser’s location or pay to transport the Product to a service facility.

WARNING! TOTO shall not be responsible or liable for any failure of, or damage to, this Product caused by either chloramines in the treatment of public water supply or cleaners containing chlorine (calcium hypochlorite). NOTE: The use of a high concentrate chlorine or chlorine related products can seriously
For more information
please call (888) 295-8134.
THIS WRITTEN WARRANTY IS THE ONLY WARRANTY MADE BY TOTO. REPAIR, REPLACEMENT OR OTHER APPROPRIATE ADJUSTMENT AS PROVIDED UNDER THIS WARRANTY SHALL BE THE EXCLU-SIVE REMEDY AVAILABLE TO THE ORIGINAL PURCHASER. TOTO SHALL NOT BE RESPONSIBLE FOR LOSS OF THE PRODUCT OR FOR OTHER INCIDENTAL, SPECIAL OR CONSEQUENTIAL DAMAGES OR EXPENSES INCURRED BY THE ORIGINAL PURCHASER, OR FOR LABOR OR OTHER COSTS DUE TO INSTALLATION OR REMOVAL, OR COSTS OF REPAIRS BY OTHERS, OR FOR ANY OTHER EXPENSE NOT SPECIFICALLY STATED ABOVE. IN NO EVENT WILL TOTO’S RESPONSIBILITY EXCEED THE PUR-CHASE PRICE OF THE PRODUCT. EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW, ANY IMPLIED WARRANTIES, INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR USE OR FOR A PARTICULAR PURPOSE, ARE EXPRESSLY DISCLAIMED. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WARRANTY LASTS, OR THE EXCLUSION OR LIMITATION OF INCIDEN-TAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION AND EXCLUSION MAY NOT APPLY TO YOU.

References

• Home - TotoUSA.com

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>