MAXIM 58710 Wafer 5 Inch RD LED Surface Mount 3000K Installation Guide
- June 9, 2024
- MAXIM
Table of Contents
MAXIM 58710 Wafer 5 Inch RD LED Surface Mount 3000K Installation Guide
Before Getting Started
- Read the instructions carefully prior to assembling the product.
- When you open the package with a sharp tool like a cutter knife, be careful not to damage the components inside.
- Carefully remove all packaging materials andretain for future use.
- Keep all hardware parts and packaging out of reach of small children.
- Choose a clean, level, spacious assembly area. Avoid hard surfaces that may damage the product.
- Ensure that you have all required contents for complete assembly.
- Take care when lifting. Assemble the product in close proximity to where you intend to position the item
- Do not over tighten the screws and bolts as this may damage the threads.
- Do not let children play with this product.
- Risk of suffocation! Keep anypackaging materials away from children.
LOW VOLTAGE LED LIGHTING INSTRUCTION
- Carefully read through the instruction sheet before assembly and using the product.
- Caution there is a risk of shock. Disconnect from power source before assembling or cleaning.
- WARNING: Wires need to be connected to driver found in canopy and should not be connected directly to power source or a short may occur.
- Do not cut factory connections unless instructed by the manufacturer
- Do not plug the product in if cord is torn or frayed
Cleaning & Maintenance
- On polished finishes, often using talc powder reduces the appearance of fingerprints and other smudges
- For respective shade surfaces, use the appropriate cleansers, i.e. glass cleaner, acrylic polish, and wood polish.
- Clean with soft cloth and a mild detergent. DO not use abrasive cleaner.
- Periodically (every 90 days) make sure that the screws are fully tightened.
- Prolonged exposure to heat sources may cause glazing, melting and scorching, or even cause color to fade.
CONTENTS
Before getting started ensure the package contains the following components.
A:
B:
C:
D:
INSTALLATION
- Prior to installation, install the mounting plate on the junction box with mounting screws. Drive screws completely to the end of the junction box.
- Connect supply wires to wires on fixture with wirenuts. Connect white to white, black to black and copper wire to copper wire as grounding connection.
- Completing the installation by pushing the fixture into the mounting plate.
WIRING DIAGRAM (ONLY FOR REFERENCE)
DO NOT ATTEMPT TO CUT FACTORY CONNECTIONS WITHOUT QUALIFIED KNOWLEDGE. MODIFICATIONS MADE TO THIS PRODUCT WITHOUT THE CONSENT OF THE MANUFACTURER WILL VOID WARRANTY.
SCHEMATIC FOR GENERAL REFERENCE ONLY
THIS FIXTURE HAS BEEN TESTED TO DIM WITH . . .
- Lutron Diva DVCL-153P
- Lutron Diva DVELV-300P
- DEAKO-Smart Dimmer
- DEAKO-Single Dimmer
- Lutron Caseta
- Lutron Skylark S-600
- Lutron Diva DVLV-600P
- Leviton Sureslide 6613-P
- Leviton Illumatech IPI06-1LZ
- Leviton Decora 6674
Note: Triac dimmer only work at 120V
FOR TECHNICAL SUPPORT contact: qc@maximlighting.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>