roll zone Wiggle Scooter User Manual

: June 9, 2024
: roll zone

Table of Contents

IMPORTANT SAFETY NOTICE. ZANGER PRECAUTIONS:
SCOOTER PARTS AND COMPONENTS OF
INSTRUCTIONS
CHECK BEFORE ASSEMBLY
MOUNTING
Read User Manual Online (PDF format)
Download This Manual (PDF format)

roll zone Wiggle Scooter

IMPORTANT SAFETY NOTICE. ZANGER PRECAUTIONS:

PRECAUTIONS: Like any other product of movement, the scooters can be a risky and can result in situations dangerous. Be sure to read the entire manual before using, in particular, pay attention to the following.

Always wear appropriate protective equipment such as helmet, elbow pads, knee pads, long sleeve shirt, gloves, pants.
Always use or suitable for sports footwear, and should not ride barefoot or in sandals.
Just mount the scooter on level ground. Do not use the scooter in wet soil or rocks or uneven terrain coarse sand. Also, do not use the scooter at night or in wet or icy conditions.
Do not ride the scooter with one hand, put both hands on the handlebars.
Do not make a skidding turns or aggressive when riding the scooter, and do not put the body on the handlebar to make a turn , the handlebar the scooter can go wrong.
Do not ride the scooter on slippery or wet ground, the wheel PU can slip and damage the scooter.
Do not ride the scooter on hills above, especially not less no long downward slope, could damage the braces.
Tighten the brake lever on the handlebar and ensure the brake is working. After continuous use the brake may be hot, and stay off the brake to prevent wounds.
Move the handlebar from left lo right and correct for make sure it works well and easily, also be sure if the handle is properly secured before riding the scooter.
All children should ride at all times with the adult supervision. Supervise, inspect the scooter before start using, making sure to press all parties to prevent accidents.
Please be followed and must obey traffic laws local security for the ride.
Do not use attachments not included with the scooter. Do not attempt lo any changes.
Ensure that all components fit together and are secured tenaciously.
The lesions may occur if these precautions are not taken.

SCOOTER PARTS AND COMPONENTS OF

PARTS LIST

INSTRUCTIONS

Open the box, please check if all parties and components are complete or not.

STEP 1 Display THE SCOOTER

Pull down the tube directing with one hand, and lift, screw in the clockwise hermetically clock in the two threads, by Please be sure that the two threads are fully tightened.
(DANGER: Make sure that your fingers are outside the folded)

STEP 2 HANDLEBAR MOUNT

Place the handlebar adjusting it the center. (NOTE: The lever brake is on the right). Cover the handle with the anchor handlebar (TOOLKIT). Screw and set al the proper angle handlebar and then tighten screws to secure.

STEP 3 FOLDING SCOOTER

Unscrew the two threads side, push the handlebar to down until it touches the foot platforms, wrap the scooter will complete with the boat for folding.
(DANGER: Make sure your fingers are outside the fold)

CHECK BEFORE ASSEMBLY

First, please make sure the brakes work.
Secondly, please check that the threads are well tight and the handle is centered and tight.
Third, please check the rear wheels can turned easily and bolts are tight.
Finally, you can start riding the scooter after to verify the above.

MOUNTING

Put your feet appropriately for the show.
Balance your body from left to right and repeat this action, then the scooter will move easily and continuously.

Installation should be done by an adult. Contact the reseller if you need any support regarding the installation. Keep small parts away from children. Inspect the product before each ride. DO NOT ride the product on roads with traffic or any dangerous situation. The use of the product is entirely at your own risk.
ADULT SUPERVISION IS REQUIRED!