frisco 345284 Automatic Cat and Dog Feeder Instruction Manual
- June 9, 2024
- frisco
Table of Contents
frisco 345284 Automatic Cat and Dog Feeder
FRISCO AUTOMATIC DOG & CAT FEEDER
13.5 CUPS, 108 0Z
INSTRUCTION
Cautions
- For indoor Use only.
- For pet use only. This product is for the feeding of s mall breed cats and dogs. Do not use it for any other purposes.
- Do not allow children to operate this product. Only abuts should operate the feeder
- Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
- Read the manual carefully and thoroughly before use.
- This product is not waterproof. The food container and feeding tray may be removed and washed with water. Do not wash feeder and tray in dishwasher.
- Before cleaning the product, disconnect the product from the power supply. To avoid shock, do not touch the pug or electrical cord with wet hands.
- Use only size D batteries for the backup power supply.
- Do not use rechargeable batteries.
- Do not mix used and new batteries.
- Make sure the batteries are installed with the correct polarity.
- Remove and dis card batteries once drained. Remove batteries if feeder is not in use for a long period of time.
- Follow local regulations in disposing of used batteries.
- This product is for dry pet foods with diameters in the range of 5-15mm. Do not unseat for canned foods or liquid foods
- Avoid touching food container or feeding tray while in use.
- Do not limpets knocker the feeder.
- Do not let pets bite the power cord. Keep cords away from pets or children.
- Discard if da mage.
WARNING
This is an electrical product. Read all directions and precautions carefully
before operating.
Failure to properly follow al directions and instructions may lead to
electrical shock or fire which could cause serious bodily injury.
- Do not use appliance for anything other than tsp. intended use.
- Position pawer cord so as to avoid pet entanglement.
- For indoor use only.
- To protect against electrical hazards, DO NOT immerse cord, plug, or appliance in water or other liquid.
- Close supervision is necessary when used by or near children.
Parts Included
Before Use
-
Releasethelidlockbyturningitcounte1dockwise, then open the food contained, lid.
-
Take out the food container.
-
Pull the feeding tray to its outermost position, then tilt the feeder back slightly about 30 degrees to remove the tray.
-
Clean the food container and feeding tray with mild detergent and allow to dry, do not wash in dishwasher.
-
Insert 3 size D batteries into the battery compartment. Ensure batteries are installed with the correct polarity, then close the compart mint cover.
-
Insert power adapter plug into the feeder’s DC socket, then plug A Cad apterin to power outlet.
Note: Installing 3-D batteries is recommended. During power outages, this auto pet feeder will continue to operate and manta in its programmed time and feeding settings.
-
Install the food container.
-
Align the feeding tray to the feeder body and push to install the feeding tray.
-
Pour pet food into the food container. Do not overfill.
-
Close the container lid, turn the lock clockwise o lock.
Display Screen
Note: Replace batteries when low battery indicator is displayed.
Programming Instructions
Programming- dock/Feeding Time/Feeding Volume.
*Press highlighted control buttons shown below to enter programming mode.
Feeding volume setting: 4 meals per day, dispensed volume selection per
meal can range from: FO1 (5 g/0.18 oz)to F20 (100 g/3.53 oz). Dispensed vole
me anabases in 5g/0.18 oz. increments.
Cancelling the Feeding Time.
Review the feeding time/feeding volume
When the screen displays the dock, presser to review the feeding time and the
feeding volume.
Modify the feeding time/ feeding volume
When the screen displays the clock, press SET and conduct steps 6-8 to modify
the feeding time and the feeding volume.
Manual instructions
When the screen displays the clock, press SET for more than 3 seconds to manually feed and release food. Vo lumen released is dependent on the set feeding volume number ranging from F01 to F20 as indicated on the display panel. Note each increment represents 5 g/0.18 oz.
*After set up is completed, pull the feeding tray out until it locks into place.
- Users can set maximum 4 meals per day, and maximum 20 servings (Approx. 100g) per meal
- Once set up is completed, the feeder will automatically dispense food at the set time.
- To quickly change the digits during the set up process, press the up and down arrows.
- If there is an outage (no power input from both the batteries and power adapter), the clock will need to be reset. However, the feeding time and feeding volume is stored and there is no need to reset.
FCC Applicable to the Adapter
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may notecase harmful interference, and
- this device must accept any interference re ceiled, including interfere nice that may cause undesired operation.
Unique Identifier
- Trade Name: CLASS 2 POWER UNIT
- Model No.: XY12)-05020000-UW
- Input Voltage: 100-240V AC, 50/60 Hz
- Output Voltage: DC4.5-36V 100-2000mA
- Power: 12W Max
Distributed by Chewy Inc.
1855 Griffin Road, Suite B-428, Dania Beach, FL 3004
1-800-672-4399
Caution: Changes made to this product that modify it beyond its
manufactured intended use could void the product’s want.
Note: This equipment has been tested and found to comply with the limits
for a Class Digital device, pursuant to part 15 of the FCC Rules These limits
are designed to provide reasonable protection against harmful interference in
a res identical installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interfere nice will not occur in a particular
installation. f this equipment does cause harmful interference to radio or
televise ion reception, which can be determined by tuning the equipment off
and on, the user is encouraged to try to correct the interference bygone or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Cleaning and Maintenance
- Check the feeder and clean the food container and feeding tray regularly.
- Only use mild detergent to wash the food container and the feeding tray. Do not use any abrasives or organics bents. Rinse with water fully after the Deanna and dry the components. Do not use feeder an drab in dishwasher.
Getting Your Pet to Use the Feeder
Some pets may need extra time to cozy unto their new feeder. If your pal doesn’t get used to it right away, place it next to their bowl to help encourage them to use it.
Storage
- For indoor use only. Keep away from an environment with high temperature and humidity.
- Place the product on a film and flat surface.
- Do not place any objects on the product.
Product Specifications
- Input Voltage:100-240V AC, 50/60 Hz
- Output Voltage: DCSV 2000mA
- Power: 1 Watts
- Measurements: 011.02in x 14.33in
Questions?
CALL OUR FRIENDLY CUSTOMER SERVICE TEAM ANYTIME. WE’RE HERE
24/711-800-67-CHEWY (672-4399)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>