LED s light 2400380 High Bay Instruction Manual

: June 9, 2024
: LED s light

Table of Contents

LED s light 2400380 High Bay
PRODUCT FEATURE
Reflector 2400380-3
DIMENSION
BOX CONTENTS
ABOUT COMPANY
Documents / Resources
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)

LED s light 2400380 High Bay

PRODUCT FEATURE

LED s-light-2400380-High-Bay-fig-2

WARNING

Risk of fire or electric shock. The electrical rating of these products are 220-240 Vac, the installer must determine whether they have
100-277 Vat the luminaire before installation.
Risk of fire or electric shock. LED Commercial High Bay installation requires knowledge of luminaires electrical systems.
IF not qualified, do not attempt installation. Contact a qualified electrician.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
Disconnect power before installing the product or servicing it.
Wait until fixture has cooled down before installing or servicing the fixture.

Reflector 2400380-3

Remove [3) protruding screws on LED High Bay. Place reflector ring within plastic reflector. Align holes on ring and plastic reflector with fixture and fasten screws back into fixture.

DIMENSION

LED s-light-2400380-High-Bay-fig-5

BOX CONTENTS

1-Led highbay
1 ring
1- bracket
l-set of screws
1 Reflector

Disconnect power before installing the product or servicing it.

Installing LED High Bay

Install the hook onto the top hole and rotate it to the end
Fasten the screw nut tightly with wrench
Fasten the security SCrew
Hook the product onto the designated location and fasten the security screw tightly.
Make all wiring connections.
Cap off dimiming wires if not used.

LED s-light-2400380-High-Bay-fig-6

Safety warning!
Ensure you have fully read and understood the instructions in this document before you install or use the product following the installation/wire diagram (when applicable\ Keep this document for future reference and only use the product as described in this document. Any other use of the product than described in this manual may damage the product or cause injury to the user (e.g. due to a short circuit. fire or electric shock). Disconnect the product from the power source if problems occur. Do not drop the product and avoid bumping. Do not use the product if a part is damaged or defective. Replace a damaged defective product immediately. When a
non-standard consumer (power)installation is required this should be performed by a qualified technician to reduce the risk of an electric shock. Make sure the product is sufficiently ventilated during use. Never cover an electrical (LED) device during usage since it can generate heat causing damage. Besides LED can be extremely bright and may cause serious eye damage so don’t stare at it directly. When a product is meant for indoor and/or outdoor use only, this will be mentioned on the product/parts or in the manual. Keep the product out of reach of children or animals.

Cleaning and Maintenance warning!
Do not use cleaning solvents or abrasives. Do not clean the inside of the device. Do not attempt to repair the device when the device does not operate correctly, replace it Clean the outside of the device using a soft, damp cloth (don’t use microfiber cloth).

Support
If you need further help or have comments or suggestions please visit www.shada.nl/nl/contact