zelmer ZGK6800 Multi Groomer User Manual
- June 9, 2024
- zelmer
Table of Contents
zelmer ZGK6800 Multi Groomer
Instruction
WE WOULD LIKE TO THANK YOU FOR CHOOSING ZELMER. WE WISH THE PRODUCT PERFORMS TO YOUR SATISFACTION AND PLEASURE.
WARNING
PLEASE READ THE INSTRUCTIONS FOR USE CAREFULLY PRIOR TO USING THE PRODUCT.
STORE THESE IN A SAFE PLACE FOR FUTURE REFERENCE
DESCRIPTION
- T-blade
- Blade length setting (0-1-2mm)
- ON/OFF button
- Trimmer guide (3-4-5-6-mm)
- Storage pouch
- Cleaning brush
- Precision trimmer
- Design trimmer
- Mini foil shaver
- Nose and ear trimmer
- LED display
- Cutting guide (3/6/9/12/15/18/21mm)
- Oil bottle
- USB charging cable
SAFETY INSTRUCTIONS
This device can be used by children aged 3 or over under supervision. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without supervision. This device can only be connected with the USB interface (5VDC, Output Max 1A). Follow the DEVICE CHARGE instructions in order to charge it.
Follow the device BATTERY REMOVAL instructions for removal of the batteries
from the device.
This device is designed for use at a maximum altitude up to 2000m above sea
level.
IMPORTANT WARNINGS
This appliance is designed for home use and should never be used for commer-
cial or industrial use under any circumstances.
Do not use the device on wet hair.
Do not use connect or disconnect the device to the mains with your hands or
feet wet. Do not use any accessories other than those supplied. Do not use
this device near to bathtubs, showers, sinks or other tanks that contain
water. The mains connection cable must not be tangled or wrapped around the
product during use. Do not pull on the cable to unplug it or use it to carry
the product.
Do not wrap the cable around the device.
Proceed according to the cleaning section of this manual for cleaning. Do not
use the product on animals.
Unplug the product immediately from the mains in the event of any breakdown
and contact an authorised Technical support service.
In order to prevent any risk of danger, do not open the device. Only qualified
technical personnel from the brand´s Official Technical support service may
carry out repairs or procedures on the device.
Any incorrect use or improper handling of the product shall render the
warranty null and void. Only an authorised technical support service centre
may carry out repairs on this product.
B&B TRENDS SL. disclaims all liability for damages that may occur to people,
animals or objects, for the non-observance of these warnings.
INSTRUCTIONS FOR USE
Always ensure the appliance is switched off before changing any attachments.
Place the desired trimming head on top of the groomer and attach the desired
cutting comb guide.
Push “ON/OFF button” (3), the trimmer is turned on and push “ON/OFF button”
again to turn it off. The display is 100% when the battery is full. The
display is LO when the battery is less than 20%.
The charging battery logo is displayed when the trimmer is charging.
You can choose between different cutting fixed comb guides 3/6/9/12/15/18/21mm
(12) or 3-4-5-6mm adjustable trimmer guide (4).
HOW TO PLACE AND REMOVE ATTACHMENTS
A detachable blade system enables you to quickly change from blade for full grooming to detail trimming blade around a moustache, goatee, or anywhere to define the hair line. To remove the attachments, simply pull top edge of blade away from the body unit. To attach, align the back tab of the attachment head to the cavity on the inner edge of trimmer unit and push down on top of blade.
T-BLADE (Fig.1)
For uniform cutting, allow the trimmer to cut its way through the hair. Do not
force it through at a faster rate.
Select the desired guide combs 3/6/9/12/15/18/18mm. Start by combing the hair
so it falls into its natural direction.
Place the largest guide comb onto your trimmer and start by trimming the sides
from the bottom upwards. Hold the trimmer lightly against the hair, with teeth
of the guide comb pointing up but flat against the head. Slowly lift the
trimmer up and outward through the hair, cutting only a small amount at a
time. Repeat around sides and back of head.
To trim your beard/moustache hold the groomer with the cutting blade facing
you. Start with edge of beard/moustache line, and with the cutting blades
resting lightly against your skin, use slow movements to create a
beard/moustache line.
PRECISION TRIMMER (Fig.7)
One adjustable comb for precision trimmer
Select the desired length on the adjustable comb 3-4-5-6mm.
Hold the groomer with the cutting blade facing you.
Start with edge of beard/moustache line, and with the cutting blades resting
lightly against your skin, use slow movements to create a beard/moustache
line.
DESIGN TRIMMER (Fig.8)
Use the design trimmer to create fine lines and contours around your facial
style, close to the skin.
Hold the design trimming head perpendicular to the skin and move the trimming
head upwards or downwards with gentle pressure.MINI FOIL
SHAVER (Fig.9)
Hold the groomer and allow mini foil shaver gently touches your face.
Use short, well-controlled movements to shave around your beard/moustache. Use
your free hand to stretch your skin. This encourages the hair to stand
upright, making it easier to shave.
NOSE AND EAR TRIMMER (Fig.10)
Insert the nose and ear attachment gently into the nostril or ear.
Gently move the groomer in and out of the nostril or ear and at the same time
rotate the groomer.
IMPORTANT: Avoid inserting the cutting unit more than 6mm into your
nostril.
CHARGING THE DEVICE
Before using your groomer for the first time, charge for 2-3 hours, and charge
2 hours regularly. Ensure the product is switched off. The hair trimmer is
complete-ly handy to carry and can be charged anywhere with the USB cable
(Fig.14). First insert the plug on the end of the USB charging cable lead into
the unit and then connect the USB charging cable to the USB interface. This
appliance is suitable for 5V DC Max 1A charger, computer and other power
interface. The LED display (Fig.11) shows remaining battery power in percent.
IMPORTANT: This product is for cord and cordless use. Your groomer cannot be overcharged. However, if the product is not going to be used for an extended period time (2-3 months), unplug it from the mains and store. Fully recharge your hair clipper when you like to use it again. To preserve the life of your batteries, let them run out every 2 months then recharge for 2-3 hours again.
MAINTENANCE AND CLEANING
Unplug the product when you do not intend to use it for an extended period of
time to prolong its shelf-life. Allow the device to cool down prior to
storage. Separate the tool head from the body and use the cleaning brush
(Fig.6) to remove dust from the internal parts. Apply a drop of oil (Fig.13)
on one of the edges of the blades for their maintenance, and turn on the
device for a few seconds to distribute it. This should be done when you notice
a certain amount of difficulty during the trimming operation.
Ensure that the device is unplugged prior to cleaning it.
This device may only be cleaned with a damp cloth, and chemical products must
never be used for the same
PRODUCT DISPOSAL
This product complies with European Directive 2012/19/EU on electrical and
electronic devices, known as WEEE (Waste Electrical and Electronic Equipment),
provides the legal framework applicable in the European Union for the disposal
and reuse of waste electronic and electrical devices. Do not dispose of this
product in the bin, instead going to the electrical and electronic waste
collection center closest to your home.
The product may contain batteries. Remove them before disposing of the product
and dispose in special containers approved for this purpose.
REMOVING BATTERY
The appliance must be disconnected from the supply mains when removing the
battery.
Ensure that the clipper is discharged of all power First remove the comb. Then
remove the blade.
Unscrew the 2 screws in the blade base of the unit. Unscrew the other screw on
the lower back housing of the clipper. Lift or pry the clipper halves apart,
exposing the battery.
Cut the metal pieces on both ends of the battery and remove it from the PCB.
Pull downward the battery set from the unit.
The battery must be removed from the appliance before it is scrapped. The
battery is to be disposed of safety
WARRANTY REPORT
B&B TRENDS, S.L. guarantees compliance of this product for the use for which it is intended for a period of two years. In the case of breakdown during the term of this warranty, users are entitled to repair or else the replacement of the product at no charge if the former is unavailable, unless one of these price or cancellation of the sale, which must be dealt with directly with the sales vendor. This also covers replacement of spare parts provided that the product has been used according to the recommendations authorised by B&B TRENDS, S.L. The warranty will not cover any parts subject to wear and tear. This warranty does not affect your rights as a consumer in accordance with the provisions in Directive 1999/44/EC for member states of the European Union.
USE OF WARRANTY
Customers must contact a B&B TRENDS, S.L. authorised Technical Service for
repair of the product. Since any tampering of the same by anyone not
authorised by B&B TRENDS, S.L., or the careless or improper use of the same
shall render this warranty null and void. The warranty must be fully completed
and delivered along with the receipt or delivery docket for the effective
exercise of rights under this warranty.
This warranty should be retained by the user as well as the invoice, receipt
or the delivery docket to facilitate the exercise of these rights. For
technical service and after-sales care outside the Polish territory, please
submit your query to the point of sale where you purchased the item or check
for further aftersales information at www.zelmer.com
Многофункциональный триммер Багатофункціональний тример
- Series: ZGK
- MOD: ZGK6800
- Input: 5V 1A
- Type: V-175
Made in China / Cделано в Китае / Зроблено в Китаї
B&B TRENDS, S.L.
C. Cataluña, 24 · P.I. Ca N’Oller
08130 Santa Perpètua de Mogoda
(Barcelona) · SPAIN
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>