SHADA 2400380-2 High Bay Installation Guide
- June 9, 2024
- SHADA
Table of Contents
2400380, 2400380-2, 2400280-3
installation manual and specifications
2400380-2 High Bay
WARNING
Risk of fire or electric shock. The electrical rating of these products are
220-240 Vac, the installer must determine whether they have 100-277 Vat the
luminaire before installation.
Risk of fire or electric shock. LED Commercial High Bay installation requires
knowledge of luminaires electrical systems.
If not qualified,do not attempt installation. Contact a qualified electrician.
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet
metal or other sharp objects.
Disconnect power before installing the product or servicing it.
Wait until fixture has cooled down before installing or servicing the fixture.
Reflector 2400380-3
Remove (3) protruding screws on LED High Bay. Place reflector ring within
plastic reflector. Align holes on ring and plastic reflector with fixture and
fasten screws back into fixture. 
BOX CONTENTS
1- led highbay
1- ring| Bracket
1 – bracket
l- set of screws| Reflector
1- Reflector
---|---|---
Disconnect pouer before installing the product or servicing it
Installing LED High Bag
- Install the hook onto the top hole and rotate it to the end
- Fasten the screw nut tightly with wrench
- Fasten the security screw
- Hook the product onto the designated location and fasten the security screu tightly.
- make all wiring connections.
Cap off dimming wires if not used.
WARNING
Safety warning!
Ensure you have fully read and understood the instructions in this document
before you install or use the product following the installation/wire diagram
(when applicable). Keep this document for future reference and only use the
product as described in this document. Any other use of the product than
described in this manual may damage the product or cause injury to the user
(e.g. due to a short circuit. fire or electric shock). Disconnect the product
from the power source if problems occur. Do not drop the product and avoid
bumping. Do not use the product if a part is damaged or defective. Replace a
damaged defective product immediately. When a non-standard consumer
(power)installation is required this should be performed by a qualified
technician to reduce the risk of an electric shock. Make sure the product is
sufficiently ventilated during use. Never cover an electrical (LED) device
during usage since it can generate heat causing damage. Besides LED can be
extremely bright and may cause serious eye damage so don’t stare at it
directly. When a product is meant for indoor and/or outdoor use only, this
will be mentioned on the product/parts or in the manual. Keep the product out
of reach of children or animals.
**** Cleaning and Maintenance warning!
Do not use cleaning solvents or abrasives. Do not clean the inside of the
device. Do not attempt to repair the device when the device does not operate
correctly. replace it. Clean the outside of the device using a soft, damp
cloth (don’t use microfiber cloth).
Support:
If you need further help or have comments or suggestions please visit
www.shada.nl/nl/contact
Caution! Risk of electric shock
The item should be disposed of separately from household waste. The item
should be handed in for recycling in accordance with local environmental
regulations for waste disposal. By separating a marked item from household
waste, you will help reduce the volume of waste sent to incinerators or land-
fill and minimize any potential negative impact on human health and the
environment.
This product carries the CE mark, which confirms that this product meets EU
safety, health and environmental protection requirements.
http://www.shada.nl/p/2400229_01
Molenmakershoek 28111-7328 JK APELDOOR11- The fletherlands • www.shada.nl
WEEE: AL: 3505,
DE: 37281017,
AT: 40133, ES: 7020
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>