onn PA2323 Wireless Party Speaker User Guide

onn PA2323 Wireless Party Speaker

WHAT’S IN THE BOX?

• 1 AC charging cable
• 1 Quick Start Guide
• 1 Wireless Party Speaker

GET TO KNOW YOUR WIRELESS PARTY SPEAKER

1. LED Display
2. Source
3. Bluetooth/Party sync
4. Power power port
5. Master volume control
6. Previous track
7. Play/Pause control
8. Next track
9. Wall light
10. Bass boost
11.  Light
12. 3.SmmAUXinput
13. Reset
14. USB Emergency
15. AC charging port
16. Microphone volume
17. Guitar volume control
18. 1/4″ Guitar port
19. 1/4″ Microphone port

**Tips:

**

• Installation must be done by qualified persons using safe rigging standards.
• The installer is responsible for proper selection and use of mounting hardware, to properly and safely pole-mount the speakers.
• Always follow instruction and precaution advice from speaker stand manufacturer.

Let’s Get Started!

The battery icon will flash when charging, and all battery segments will be lit and remain solid white once fully charged.

Fully charge the battery if you might not use this speaker in the near future. Place it in a cool, dry place. Recommend to charge it at least one time for every half year, in order to keep the battery performing well. Empty battery too long may result in fewer hours of usage between , charges.

Built-in Rechargeable Li-ion
Battery: 14.8V 2500mAh

Connect your Wireless Party Speaker

Connect to your device through Bluetooth® wireless technology, search for the entry “onn. Party Speaker L”.

PLACEMENT
Caution: Do not sit or lean on the speaker or push it sideways to avoid tip- over and possible damages.
Place the speaker on a flat, stable surface and ensure that the rubber feet side is down.

Want your Party to the Next Level?

1. Power on both speakers, press & hold of each speaker to enter Party Sync Mode.
2. When two speakers paired, you will hear left channel, right channel. The left channel is the master.
3. Use your mobile device to pair with the master speaker by Bluetooth pairing method.
4. Press & hold again to disconnect Party Sync Mode.

Wired Use? Yes!

1. Use a 3.5 mm AUX cable (not included) to connect the speaker to your audio source.
2. In AUX mode, can’t be used, you can ONLY control them by your audio source device.

Listen to Your Favorite Radios

1. Press to select FM mode.
2. Press or to scan and select FM stations step by step.
3. Press& hold or to seek (jump to the next available station).
4. In FM Mode, press and hold to assign the current station to a preset number, the LED screen will show “SAV” to show the station has been saved. The preset number can be changed by pressing and .
5. In FM Mode , press repeatedly to select a saved radio station.

Want to Sing A Song?

1. Connect your Microphone (not included) or Guitar (not included) to the MIC or GUITAR port.
2. Play Guitar through the speaker.
3. Sing along with the Microphone when music played on Bluetooth/AUX-/FM mode.
4. Rotate the MIC or GUITAR knob to adjust the Microphone or Guitar volume.

Want More Lighting Effects?

1. Press & hold to turn on/off the light.
2. Press once to turn on/off the light effect.
3. Quick press to switch between 6 different multicolor LED lightings.

Charge Your Device

USB-A charging port with emergency power can charge your other smart devices (5V 2.1A output), when this Wireless Party Speaker is powered on.

But Wait … There’s More!

• Do not sit or lean on the speaker or push it sideways to avoid tip-over and possible damages.
• Place the speaker on a flat, stable surface and ensure that the rubber feet side is down.
• Always keep the charging port dry before connecting AC power.
• To ensure it is waterproof, always close the protective cover securely.

LEGAL & COMPLIANCE

1. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
2. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules and ISED Canada License- exempt RSS Standard(s). Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

This equipment should be installed and operated with a minimum distance of 20 cm between the radiator and your body.

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions – All the safety and operating instructions should be read before this product is operated.

2. Keep these instructions – The safety and operating instructions should be retained for future reference.

3. Heed all warnings – All warnings on the appliance and in the operating instructions should be adhered to.

4. Follow all instructions – All operating and use instructions should be followed.

5. Do not use this apparatus near water – The appliance should not be used near water or moisture – for example, in a wet basement or near a swimming pool, and the like.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat.

9. Do not defeat the safety purpose of the polarized or grounding plug. A polarized plug has two blades with one wider than the other. A grounding plug has two blades and a third grounding prong. The wide blade or the third prong is provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at the plugs, convenience receptacles, and at the point where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the apparatus. When a cart or rack is used, use caution when moving the cart/apparatus combination to avoid injury from tip-over.

13. Unplug the apparatus during lightning storms or when unused for long periods of time.

14. Refer all servicing to qualified personnel. Servicing is required when the apparatus has been damaged in any way, such as power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the apparatus has been exposed to rain or moisture, does not operate normally, or has been dropped.

15. Do not install this equipment in a confined or built-in space such as a book case or similar unit, and maintain well-ventilated conditions. The ventilation should not be impeded by covering the ventilation openings with items, such as newspaper, tablecloths, curtains, etc.

16. WARNING: To reduce the risk of fire or electric shock, do not expose this apparatus to rain or moisture. The apparatus shall not be exposed to dripping or splashing and that objects filled with liquids, such as vases, shall not be placed on apparatus.

17. WARNING: The mains plug is used as disconnect device, the disconnect device shall remain readily operable.

18. This equipment is a Class II or double insulated electrical appliance. It has been designed in such a way that it does not require a safety connection to electrical earth.

19. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of non-insulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock.

    • Warning: To reduce the risk of electric shock, do not remove cover (or back) as there are no user-serviceable parts inside. Refer servicing to qualified personnel.
    • The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance instructions in the literature accompanying the appliance.

20. The equipment shall be used at maximum 35 degree C ambient temperature.

CAUTION: Risk of explosion if the battery is replaced by an incorrect type

• replacement of a battery with an incorrect type that can defeat a safeguard (for example, in the case of some lithium battery types);
• disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
• leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;
• a battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas. Rating lable is located at the bottom of the product. The equipment is waterproof only when placed vertically, it is not waterproof when placed sideways.

Party sync mode compatible model list

100008734
100008736
100094812
100094813
100097809
AAAGRY100006897
AAAAQU100006897
AAAGRY100006902
AAAGRY100006896

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>