nureva HDL200 Audio Conferencing Systems Instructions
- June 9, 2024
- nureva
Table of Contents
nureva HDL200 Audio Conferencing Systems Instructions
IMPORTANT WARNINGS
Prior to installing this product, ensure you fully read and understand the installation instructions. Failure to do so could result in personal injury or property damage. The installer is responsible for ensuring all components are properly assembled and installed using the instructions provided. Keep this information sheet and related product manuals for future reference.
IMPORTANT: Never operate this equipment if it is damaged. Disconnect the power cable from the wall outlet and seek assistance from qualified service personnel if any of the following occur:
- The power cable or plug is damaged
- Liquid is spilled onto the product
- The casing on the unit is cracked or damaged
- The product doesn’t work properly when the operating instructions are followed
SAFETY WARNINGS
The manufacturer shall not be legally responsible for any property damage or personal injury caused by incorrect installation of the equipment or operation not covered in the user’s manual. The manufacturer shall not be liable for damage to property or personal injuries arising out of factors beyond the manufacturer’s control.
WARNING: Do not open or modify the parts or accessories. Opening the equipment’s case voids the warranty and also exposes you to risk of electrical shock. Do not use with parts or accessories not provided by the manufacturer.
WARNING: The equipment must be installed by qualified personnel. Failure to provide adequate structural strength for the mounted equipment can result in serious personal injury or property damage. The wall anchors must be able to support four mes the equipment weight. Therefore, the anchors for the integrated microphone and speaker bar must be able to support 50 lb. (22.7 kg).
WARNING: Adding addional weight to the mounted equipment by leaning, hanging or storing items on it can result in serious personal injury or property damage.
WARNING: Do not expose the equipment to moisture or damp environments. This equipment is not intended for outdoor use.
WARNING: Only use the power supply that is provided with this equipment. Only use extension cords and outlets that properly accommodate the equipment’s polarized plug. Ensure that any cables used with the equipment are properly bundled, routed, covered or constrained if they cross the floor or pose a tripping hazard.
WARNING: This product can expose you to c hemicals including Diisononyl phthalate (DINP), which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.
IMPORTANT: Follow all installation methods in accordance with the applicable country electrical codes, regional codes and local codes or ordinances. Follow all applicable guidelines, regulations and laws for handling and liting the unit during installation.
IMPORTANT: Do not use chemical or abrasive cleaners on the equipment.
FCC Part 15 Class A Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions
- This device may not cause harmful interference.
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residental area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
Modifications: Changes and Modifications not expressly approved by the manufacturer of this equipment can void your authority to operate this equipment under Federal Communications Commission’s rules.
Industry Canada Statement
This digital apparatus does not exceed the Class A limits for radio noise
emissions from digital apparatus set out in the Radio Interference Regulations
of Industry Canada
WEEE Statement
To return any product for proper treatment and recycling, contact your local
authority or your local reseller.
© 2022 Nureva Inc. All rights reserved. Nureva and the Nureva logo are trademarks or registered trademarks of Nureva Inc. in the United States, Canada and other countries.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>