HINKLEY 51090 16w Integrated LED Bath Bar Instruction Manual
- June 9, 2024
- HINKLEY
Table of Contents
HINKLEY 51090 16w Integrated LED Bath Bar
Preparation
- Find a clear area in which you can work.
- Unpack fixture and glass from the carton.
- Carefully review instructions prior to assembly.
Installation
- To install glass (G) unscrew the knob on the side of the fixture (K)
- Next, remove screw (S) that holds L arm (L) to fixture
- Remove L arm (L) from the fixture
- Remove spacer (B) and glass cap (C) from the fixture
- Slide glass (G) onto the fixture
- Replace spacer (B) and glass cap (C)
- Replace L arm (L), screw (S), and knob (K) (this will lock the glass into place)
- Release mounting plate (A)from the fixture by unscrewing the four-barrel knobs (Z) on the front of the fixture. Keep screws (V) attached to the mounting plate.
- Secure mounting plate (A) to the junction box using tw 8- 32 screws (F) (not provided)
- Complete wiring connections using IS-18 on the next page (make sure the power is off before completing any wiring)
- Replace the four-barrel knobs (Z) to complete fixture mounting
- The fixture can now be powered on
SAFETY WARNING
READ WIRING AND GROUNDING INSTRUCTIONS (I.S. 18) AND ANY ADDITIONAL DIRECTIONS. TURN THE POWER SUPPLY OFF DURING INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A QUALIFIED ELECTRICIAN OR LOCAL AUTHORITIES FOR CODE REQUIREMENTS.
Make electrical connections from supply wire to fixture lead wires. Refer to the instruction sheet (I.S. 18) and follow all instructions to make all necessary wiring connections. Then refer back to this sheet to complete the installation of this fixture.
HINKLEY 33000 Pin Oak Parkway, Avon Lake, OH 44012 800.446.5539 / 440.653.5500 hinkley.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>