VOLT VPL-1050-4-BBZ Modernelle Brass Path and Area Light Instruction Manual
- June 3, 2024
- VOLT
Table of Contents
VOLT VPL-1050-4-BBZ Modernelle Brass Path and Area Light
INSTALLATION INSTRUCTIONS
Important : Please Read Before Installation
This luminaire is intended for installation in accordance with local codes and the National Electric Code (NEC). Failure to adhere to these codes and instructions may result in serious injury, property damage and void the warranty. These instructions do not intend to cover all variations in installation, operation maintenance or mounting situations.
- Make sure that the power is turned OFF before installing or servicing this fixture.
- Warning : this fixture is not intended to be installed within 10 feet [3 meters] of a pool, spa or fountain.
- This fixture is intended to be used only with a power supply (transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
- Underground Low Energy Cable must not be buried over 6” (15.2 cm) in order to connect to the main low voltage cable.
- Wiring connections must be made with UL Listed wire connectors that are suitable for the application.
- Position the wire connector so that it is located within 6 inches (15.2 cm) from a building structure, a luminaire, or fitting.
Important Safety Instructions
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS Lighted lamp
is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
- Turn off/unplug and allow to cool before reducing lamp.
- Lamp gets HOT quickly!
- Do not touch the hot lens, guard or cowl.
- Keep lamp away from materials that may burn.
- Do not touch lamp at any time.
- Use a soft cloth.
- Oil from skin may damage lamp.
- Do not operate the fixture with a damaged or missing lens or shield.
Package Contents
(1) Fixture Body
Parts Required (Sold Separately)
- A. (1) Mounting Accessory
- B. (1) Flat Bi-Pin LED Bulb
Product Dimensions
Remove Lens
Using a screwdriver, loosen screws on the lens and remove the lens from the
shade.
Install Bulb
Insert bulb with correct wattage and type marked on fixture label and push
into place.
CAUTION : Do not exceed maximum wattage marked on fixture label
Install Lens
Place the lens back onto the shade and secure with previously removed screws.
Tighten until snug with screwdriver.
Install Stake
Determine the desired location for mounting the luminaire. Hammer the stake
into the ground until flange of stake is flush to grade. To avoid damage to
the stake, place a board on top of the stake while hammering.
Note : If the ground is hard and the stake is difficult to install, make a crosscut in the ground using a flat shovel
Install Fixture Body to Stake
Pass supply wires through the center hole of the stake and thread the stem
onto the stake. Hand tighten until snug. Clear away area in ground and lay
supply wires into wireway slots.
Wire Connections
Strip two leads from fixture wires. Using two UL listed wire connectors (sold separately), connect leads from fixture wires to main supply cable leads.
Install/Replace Bulb
Please reverse Step 1 – Step 3 to expose the bulb and replace it with the correct wattage and type marked on the fixture label.
IMPORTANT : The Bulb must be protected from moisture and dust at all times. Always reinstall the lens when removed.
Help Hotline:
1-813-978-3700 Mon-Fri 8am-8pm Sat-Sun
10am – 6pm (EST) Specifications and product details subject to change without
notice. © Copyright 2022, VOLT® Lighting, Lutz FL USA 33549 All rights
reserved.
customersupport@voltlighting.com
813.978.3700 IS-VPL-1050-4-BBZ-ver1.pdf
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>