MAXIM Counter Max MX-L-120-5K Basic 2700-5000K LED Under Cabinet User Guide
- June 9, 2024
- MAXIM
Table of Contents
MAXIM CounterMax MX-L-120-5K Basic 2700-5000K LED Under Cabinet
Before Getting Started
Read the instructions carefully prior to assembling the product.
When you open the package with a sharp tool like a cutter knife, be careful not to damage the components inside.
Carefully remove all packaging materials and retain for future use.
Keep all hardware parts and packaging out of reach of small children.
Choose a clean, level, spacious assembly area.
Avoid hard surfaces that may damage the product.
Ensure that you have all required contents for complete assembly.
Take care when lifting. Assemble the product in close proximity to where you intend to position the item.
Do not over tighten the screws and bolts as this may damage the threads.
Do not let children play with this product.
Risk of suffocation!
Keep any packaging materials away from children.
Lamp Care Instructions
Carefully read through the instruction sheet before assembly and using the product.
Caution there is a risk of shock. Disconnect from power source before assembling or cleaning.
Switch off, unplug and allow bulb to cool before replacing bulb or cleaning.
Only use the recommended bulb type and do not exceed the maximum wattage as it could cause fire.
Do not plug the product in if cord is torn or frayed.
For outdoor use, caulk around fixture with silicone sealant to prevent water intrusion.
Cleaning & Maintenance
Apply a high quality car wax to the fixture regularly to protect from environmental factors that can damage the metal.
Clean with soft cloth and a mild detergent.
DO not use abrasive cleaner.
Periodically (every 90 days) make sure that the screws are fullvtiahtened.
Prolonged exposure to heat sources may cause glazing, melting and scorching, or even cause color to fade.
Parts
Ⓐ
| 
LAMP| x1
---|---|---
Ⓑ
| Romex Connection kit| x1
Ⓒ| 
SCREW|
x2
Ⓓ| 
LINKING
CABLES (SOLD SEPERATELY)|
x1
Installations Instructions
-
Fix the fixture to the unit using 2 fixing screws
-
Connect the multiple fixtures by snapping the End to End Connector or Jumper Connector.
-
Finally wire the power cord to 120v mains supply.
-
By flipping the switch (a) select between one of the 3 modes (Lo, Off, Hi).
Switch {b) is used to change the color temperature of light delivered 2700K, 3000K & 3500K 4000K 5000K CCT respectively.
Hardwire Installation
-
Remove the kick-out by hammering
-
Disengage adapter plate by loosening screw.
-
Insert Romex connector into the housing open hole on the adapter plate. Secure it with the nut.
-
Pull 3 wires out of the fixture to allow connection to the branch circuit.
Inserting wires into the open hole in the push-in wire connector
-
Connect the Green ground input supply wire to the fixture Green ground wire.
Connect the White input supply wire to the fixture White wire.
Connect the Black input supply wire to the fixture Black wire.
**Do not mix wires or change polarity.
-
Feed wires back into fixture, reattach adapter plate tighten screw, and attach the fixture to the base of the cabinet, with screws
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>