Audiocontrol B01EE3Y53Q The Epicenter Bass Booster Expander & Bass Restoration Processor User Guide
- June 2, 2024
- AudioControl
Table of Contents
B01EE3Y53Q The Epicenter
Bass Booster Expander &
Bass Restoration Processor
User Guide
B01EE3Y53Q The Epicenter Bass Booster Expander & Bass Restoration
Processor
Quick Start
- The Epicenter is active and REQUIRES CONSTANT +12V POWER
- Protect The Epicenter from heat, moisture, and dirt.
- Use the integrated mounting brackets to mount the The Epicenter.
- Don’t drill through fuel lines, brake lines, or electrical wiring.
Install It
The Epicenter needs to be
installed between a source and an external amplifier. Although it can be
installed after an equalizer, it should be installed BEFORE A
CROSSOVER.
Power it Up
Connect the +12V input terminal to the +12V terminal on the vehicle battery
(or distribution block) using 16 to 14 AWG. Connect the Ground terminal to the
Ground/Negative terminal of the battery (or distribution block) using the same
gauge wire as the +12V power wire. Connect the Remote terminal to a switched
+12V remote turn on source, i.e., a head unit or switch. ACR-1 Dash Remote
(included)
Bass Restoration level can be controlled from the included ACR-1 Dash Remote.
You can mount the knob anywhere you want, although somewhere in the front of
the vehicle is preferable. Connect the remote cable to the Dash Remote input.
Shape that Bass
The ParaBASS Controls allow you to shape The Epicenter bass restoration effect
to your specific application and vehicle acoustics. 
The Sweep control allows you to select a center frequency (the
frequency most affected) between 27 and 63 Hz.
The Wide control allows you to control the shape of the filter
centered around the Sweep frequency.
Specifications
| MAXIMUM INPUT LEVEL | 15 VRMS |
|---|---|
| MAXIMUM OUTPUT LEVEL | 13.5 V PEAK |
| SIGNAL TO NOISE | 110 DB |
| FREQUENCY RESPONSE | 10 HZ – 22 KHZ |
| TOTAL HARMONIC DISTORTION | 0.00% |
| SIGNAL TO NOISE RATIO | -130 DB |
| INPUT / OUTPUT IMPEDANCE | 10K OHMS / 150 OHMS |
| POWER DRAW / RECOMMENDED FUSE RATING | 150 MA / 1 A |
| BEVERAGE OF CHOICE | REUBEN’S BREWS STAY FROSTY IPA™ |
| WEIGHT / DIMENSIONS | 1.7 LBS / 8.0”W X 5.5”D X 1.2”H |
Need more help? Scan the QR code on the back of this card for the
complete Owners Enjoyment Manual.
- Epicenter Logo (backlit with cool blue LEDs)
- Sweep Knob (adjusts ParaBASS center frequency)
- Wide Knob (adjusts ParaBASS bandwidth)
- Balanced Line Level Inputs
- Line Level Outputs
- Input for ACR-1 dash remote (included)
- Power Connector
- Power LED
- [Internal] PFM Subsonic Filter
- [Internal] Input Grounding
- [Internal] Ground Isolation Jumper
- [Internal] Bass Output Control Jumper
For more information on internal features refer to the Owners Enjoyment Manualhttps://www.audiocontrol.com/downloads/car/current/epicenter-le /epicenter-le-user-manual.pdf
©2021 AudioControl.
All rights reserved.
www.audiocontrol.com
P/N 915-026-0 Rev A
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>