Aqara RTCGQ11LM Motion Sensor User Guide

: June 4, 2024
: Aqara

Table of Contents

Aqara RTCGQ11LM Motion Sensor
Product Introduction
Quick Setup
Installation
Specifications
ABOUT COMPANY
Federal Communications Commission (FCC) compliance statement
References
Read User Manual Online (PDF format)
Download This Manual (PDF format)

Aqara RTCGQ11LM Motion Sensor

Product Introduction

Aqara Motion Sensor detects human movement with passive infrared. It works with other smart accessories to set various scenes, such as, turning on or off lights automatically when it detects activity or inactivity. It consumes low energy. No tools are required to install it, and you can simply place or stick it almost anywhere.

A hub is required.
Aqara Hub is required to enable Aqara Motion Sensor to work with HomeKit technology. See www.aqara.com for more details.
- This product is for indoor use only.

Aqara RTCGQ11LM Motion Sensor-fig2

Quick Setup

Please add the Hub to the app according to the Hub Quick Start Guide.
Please open the app, tap “Home” and then tap “+” in the top right corner to enter “Add Device(Accessory)” page. Select “Motion Sensor” , and add it according to instructions.
If the connection fails, please move the accessory closer to the Hub and try again.

Installation

Effective Range Test: Single press the reset button on the accessory at your desired position. If the Hub makes voice prompts, it indicates that the accessory can communicate effectively with the Hub.
Avoid metal surface to maximize signal strength.
Option 1: Place the Motion Sensor where you need it.
Option 2: Remove the protective film (the round sticker is in the box), and stick it to the desired position.

Option 3: Stick the Motion Sensor to the stand, and stick the stand to where you need it.
- The recommended installation height is 1.2 m to 2.1 m. If the installation height is below 1.2 m, the detection area will decrease; if above 2.1 m, the detection area might have blind spots.
- Note that the lens should be aligned with the detection area when installing, and placed or pasted as close as possible to the edge of a table or cabinet.

Specifications

Model: RTCGQ11LM
Dimensions: 30 × 30 × 33 mm (1.18 × 1.18 × 1.30 in.) Wireless Protocol: Zigbee
Battery: CR2450
Maximum Detection Distance: 7 m
Maximum Detection Angle: 170°
Operating Temperature: -10° – +45° C
Operating Humidity: 0 – 95% RH, no condensation
Online Customer Service: www.aqara.com/support
Email: support@aqara.com

ABOUT COMPANY

Manufacturer: Lumi United Technology Co., Ltd.
Address: 8th Floor, JinQi Wisdom Valley, No.1 Tangling Road, Liuxian Ave, Taoyuan Residential District, Nanshan District, Shenzhen, China.

Federal Communications Commission (FCC) compliance statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body.