WELLFOR CJJSBM Series Bathroom Mirror Instruction Manual
- June 3, 2024
- WELLFOR
Table of Contents
WELLFOR CJJSBM Series Bathroom Mirror
CJJSBM3648D KSXFLX
CJJSBM6036D KSXFLX
CJJSBM7236DKSXFLX
CJJSBM4836D KSXBLX
WARNING AND SAFETY INSTRUCTIONS
Before assembling your LED Lighted Mirror fixture, please make sure that you carefully read through this instruction sheet, refer back to them during installation to ensure your product is fitted safely and correctly. Keep these instructions for future use.
WARNING Risk of Fire and Electric Shock
- All fittings must be installed in accordance with current IEE wiring regulations. If in doubt, consult a qualified electrician.
- Switch off the electrical supply at the main ci rcuit board BEFORE installation and maintenance.
- Suitable for indoor use only. This product should be positioned well awayfrom curtains and fabrics. Never cover the mirror.
- Regularly check the cord, the transformer and all other parts for damage. If any part is damaged the product should not be used.
INSTALLATION SAFETY
- Inspect the product immediately upon receipt for the transit damage ormissing parts. Handle the product with care and protect against knocks to all sides and edges of the glass.
- Ensure there are no hidden pipes or cables in the wall before drilling.
- Wear suitable eye protection when drilling. Take care if drilling on t iled surfaces in case the drill slips
CAUTION
The light source of this product is non-changeable light diodes (LED). Do not
disassemble the product, as the light diodes can cause damage to the eyes.
NOTE: The important safeguards and instructions that appear in this
manual are not meant to cover all possible conditions and situations that may
occur. It must be understood that common sense, caution and care, are factors
that can’t be built into any product. These factors must be supplied by the
person(s) caring for and operating the fixture. Do not install this fixture in
hazardouslocations.
CHECK PRODUCT LIST AFTER OPENING THE PACKAGE
- LED Lighted Mirror –1 pcs
- Screws for wall –4 pcs
- Plastic Anchor – -4 pcs
- Mounting bar –2 pcs
- Installation Manual –1 pcs
INSTALLATION MANUAL
-
Level and mark the location.
-
Place the mounting bar against the wall and make some marks on the wall
-
Drill the holes and place the suitable plastic anchors.
-
Screw the mounting bar onto the wall with the screws.
-
Connect the mirror with the main supply.
• We provide plug with mirrors.
• Optional to cut the plug directly,then connect to electrical wiring if using wall switch.
ATTENTION: PLEASE CUT OFF THE MAIN POWER SUPPLY BEFORE WIRING!
-
Hang the mirror onto the mounting bar.
OPERATION INSTRUCTION
ON/OFF and CCT adjustment|
- Button turns blue when connected to main supply.
- Button turns blue when connected to main supply.
---|---
|
- Short-touch the button to turn on/off the mirror.
- Adjusting color temperatures (CCT) between warm white and cool white by long-touching the button for seconds.
- Finish setting by withdrawing your finger when the color reaches the one you need.
- Optional to be wired to wall switch by ON/OFFmemory function.
ON/OFF and Dimmer
Press and hold on for 3-5 seconds
|
- Short-touch the button to turn on/off the mirror.
- Long touching the button to adjust thebrightness (Dimming) .
Anti-Fog Function
Defogger button
|
- Mirror begins to be warm and defog after pressing the defogger button. Press again to quit the anti-fog function.
- Note: The defogger will stop automatically after 60 minutes of continuous operation to prevent any damage caused by prolonged high temperature.
AFTERCARE INSTRUCTIONS
Clean using a soft dry cloth only when turned off. Never use cleaning agents or abrasive materials. Do not allow moisture to come into contact with lamp.
THANK YOU FOR YOURSUPPORT
Documents / Resources
|
WELLFOR CJJSBM Series Bathroom
Mirror
[pdf] Instruction Manual
CJJSBM4836DKSXBLX, CJJSBM3648DKSXFLX, CJJSBM6036DKSXFLX, CJJSBM7236DKSXFLX,
CJJSBM Series Bathroom Mirror, CJJSBM Series, Bathroom Mirror, Mirror, CJJSBM
Series Mirror
---|---