YUNMAI Smart Scale 3 User Manual

June 3, 2024
YUNMAI

Smart Scale 3
User Manual

YUNMAI Smart Scale 3

Smart Scale 3

Warning

Do not disassemble, squeeze, puncture the product or put it into water, fire, or expose to tempreature highter than 60°C (140oF).
Important
The measurements taken by YUNMAI smart scale are for reference only and are not intended as medical advice.
Note
Following groups may not get accurate results:

  • Juveniles
  • Professional athletes
  • Pregnant women
  • Users with Cardiac Pacemaker device

Measurement

  • It is easy to slip if you use the smart scale in wet conditions.
  • After moving the scale, it is necessary to keep it still for 5 seconds to allow the sensor to be calibrated with the ground, so that you can get accurate data when using the scale.

Maintenance

  • Use a damp cloth to wipe the surface of the scale.
  • Do not use any detergents or cleansers for cleaning.

Caution
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Pal-15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment OFF and ON, the user is encouraged to try to correct the interference by one or more of the following measures:

  • Reorient or relocate the receiving antenna.

  • Increase the separation between the equipment and receiver.

  • Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

  • Consult the dealer or an experienced radio/TV technician for help.
    This device complies with Partl 5 of the FCC Rules. Operation is subject to the following two conditions:

  • This device may not cause harmful interference, and

  • This device must accept any interference received, including interference that may cause undesired operation.

Product Information

Thank you for choosing YUNMAI Smart Scale 3.

YUNMAI Smart Scale 3 - 1

  • Charging port: Please use the Type-C charging cable.
  • RESET: Press and hold for 5 seconds to restore factory settings.
  • Power switch: Long press for 2 seconds to turn on/off.

Screen Display

| Bluetooth icon: The constant white light indicates normal connection, while the flashing white light indicates disconnection.
---|---
| Fat measurement icon: The constant white light indicates fat measurement in progress, while the flashing white light indicates fat measurement failure.
| Weighing with baby icon: This function needs to be launched from the APP.
| Power indicator icon: The constant white light indicates low power. Please charge in time.
| Body fat percentage icon: The constant white light indicates measuring and displaying body fat percentage.

Special Notes

  • Low battery alert: Only displayed when the battery is low. Please charge it in time and do not measure on the scale when it is charging.

Install YUNMAI App
Search for “YUNMAI” on the Google App Store or Apple App Store, or scan the QR code below to download and install APP and connect it with your device.
The mobile App downloaded via other channels might be unusable. Before connecting the App with your device, please make sure that your device meets the following requirements:

  • Compatible with iPhone devices running iOS 12 or above.
  • Mobile devices running Android 5.0 or above and equipped with Bluetooth 5.0.

Scan QR Code
Download official YUNMAI Smart Scale 3 - qr
codehttp://www.iyunmai.com/intapp/

Connect To The Scale Via Bluetooth

Turn on the Bluetooth option on your mobile phone and open the YUNMAI App to automatically connect to the device. Get on the scales and measure, then you can synchronise the data in real time to your mobile phone for display and recording.

YUNMAI Smart Scale 3 - 3

iOS Bluetooth switch: Slide from the bottom of the screen to open the Control Center and click on the [Bluetooth] logo| Turn on Bluetooth on Android device: open the YUNMAI App and click [Allow] when the Bluetooth pop-up window appears

Start Using

Start recording your weight and body data immediately. To get on the scale for measurement, take the centre as the origin and position your feet naturally on both sides, with the forefoot on the front half of the pattern and the heel on the back half of the pattern, as shown in the picture below.

YUNMAI Smart Scale 3 - 4

Note: To ensure the accuracy, please stand on the scale barefoot with the right posture.

YUNMAI App

Live well, live lighter! With the YUNMAI App, you can not only record your weight changes, exercise consumption, dietary intake and other basic information, but also use the YUNMAI Smart Scale to comprehensively check a number of body data, perform intelligent analysis in the cloud and get health reports and suggestions for improvement.

Note: Due to the rapid iteration of the YUNMAI App, the features listed on this page are based on the actual product and are subject to change without notice.

Basic Parameter

Product Name: Yunmai Smart Scale 3
Model: YMBS-5282
Measurement Unit: kg, lb
Connection: Bluetooth°5.0 Size: 30030025mm
Battery Capacity: 600mAh
Bluetooth transmission frequency band: 2400-2483.5MHz| Net Weight: approx. 1.6kg/3.51b
Weighing Range: 0.1-150kg/0.2-330.71b
Accuracy: 0.05 kg
Working Temperature: -5°C-40°C
Battery Type: Lithium battery
Rated Input: DC 5V 0.5A
---|---

WEEE
All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the environment and human health. Please contact the installer or local authorities for more information about the location as well as terms and conditions of such collection points.

Battery Directive – Information for Users

In the European Union, this label indicates that the batteries in this product should be collected separately and not be disposed of with household waste. Substances in batteries can have a potential negative impact on health and environment and you have a role in recycling waste batteries thus contributing to the protection, preservation, and improvement of the quality of the environment. You should contact your local authority or retailer for details of the collection and recycling schemes.
Hereby, Shenzhen Yunmai Technology Co.,Ltd declares that the radio equipment type YUNMAI 3 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.yunmaiglobal.com

Please visithttps://www.yunmaiglobal.com
Email:support@iyunmai.com
Instagram: @yunmaiglobal
Facebook: @yunmaiglobal
Manufacturer: Room 01, 18-19 / F, Chiwan Headquarters Building
Zhaoshang Street, Nanshan District, Shenzhen 518000 Guangdong
P.R. China

Documents / Resources

| YUNMAI Smart Scale 3 [pdf] User Manual
S282, 2AX9A-S282, 2AX9AS282, Smart Scale 3, Smart Scale, Scale 3
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals