YUNMAI X Smart Scale Body Analyzer User Guide
- June 13, 2024
- YUNMAI
Table of Contents
User Manual
Warning
De not arbitrarily disassemble, crush, puncture, short-circuit batteries, or put them into water, fire, or expose them to temperatures above 60° C (140° F).
Important
The measurements taken by YUNMAI smart scale are for reference only and are not intended as medical advice.
Note
Following groups may not get accurate results:
- Juveniles
- Professional athletes
- Pregnant women
- Users with Cardiac Pacemaker device
Measurement
- It is easy to slip if you use the smart scale in wet conditions.
- After moving the scale, it is necessary to keep it still for 5 seconds to allow the sensor to be calibrated with the ground, so that you can get accurate data when using the stale.
Maintenance
- Use a damp cloth to wipe the surface of the scale.
- Do not use any detergents or cleansers for cleaning.
Product Information
Thank you for choosing YUNMAI X.
Charging port : Please use the Type-C charging cable.
RESET : Press to restore factory settings.
Power switch : Long press for 2 seconds to tum an/off, short press to switch
the weighing unit of the scale.
Screen display
Flashing indicates the measurement of body fat is in progress. Constantly
keeping on indicates successful measurement. Flashing and then turning off
indicates measurement failure.
Flashing indicates low battery. After connecting the charging cable, it will
breathe with 2 flashing light to indicate charging status. Constantly keeping
on indicates a full charge.
Special Notes:
Low battery alert: Only displayed when the battery is low. Please charge it in
time and do nat measure on the scale when it is charging.
After-sales Service
YUNMAI provides permanent technical support and a one-year hardware warranty.
Install YUNMAI App
Search for “YUNMAI” on the Google App Store or Apple App Store, or scan the QR
code below to downloads and install APP and connect it with your device.
The mobile App downloaded via other channels might be unusable. Before
connecting the App with your device, please make sure that your device meets
the following requirements:
- Compatible with iPhone devices running iOS 12 of above.
- Mobile devices running Android 5.0 or above and equipped with Bluetooth 5.0.
http://www.iyunmai.com/intapp/
Connect to the scale via Bluetooth
Turn on the Bluetooth option on your mobile phone and open the YUNMA! App to
automatically connect to the device. Get on the scales and measure, then you
can synchronize the data in real time to your mobile phone for display and
recording.
iOS Bluetooth switch: Slide from the bottom of the screen to open the Control
Center and click on the [Bluetooth] logo.| Turn on Bluetooth an Android
device:
open the YUNMAI App and click [Allow] when the Bluetooth pop-up window
appears.
Start using
Start recording your weight and body data immediately. To get on the scale for
measurement, take the centre as the origin and position your feet naturally on
both sides, with the forefoot on the front half of the pattern and the heel on
the back half of the pattern, as shown in the picture below.
|
---|---
Correct
Feet over all four sensors.| Wrong
Feet going out of the verge may affect the accuracy.
|
wrong
Standing in wrong direction will shield the screen.| wrong
Feet not in a line may affect the accuracy.
Note: To ensure the data accuracy, please stand on the scale barefoot with the right posture.
YUNMAI App
Live well, live lighter! With the YUNMAI App, you can not only record your weight changes, exercise consumption, dietary intake and other basic information, but also use the YUNMAI Smart Scale to comprehensively check a number of body data, perform intelligent analysis in the cloud and get health reports and suggestions for improvement.
Note: Due to the rapid iteration of the YUNMAI App, the features listed on this page are based on the actual product and are subject to change without notice.
Specifications
Product Name : YUNMAI X Smart Scale
Model : YMBS-M268
Net Weight : Approx 1.1 kg/2.4lb
Measurement Unit : kg, (b
Accuracy : 0.05 kg
Weighing Range : 3-150 kg/6.6-330.7lb
Connection : Bluetooth 5.0
Working Temperature : 0°C ~40°C
Size : 260°260°25 mm
Battery Type : Lithium battery
Battery Capacity : 235 mAh
Rated Input : DC 5V 0.54
Maximum RF Output Power : 0 dBm
Bluetooth Transmission Frequency Band : 2402-2480MHz
FCC Statement
FCC ID: 2AX94-YMBS-M268
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy, and if
not installed and used in accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the
equipment OFF and ON, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WEEE Information
****All products bearing this symbol are waste electrical and electronic equipment (WEEE as in directive 2012/19/EU) which should not be mixed with unsorted household waste. Instead, you should protect human health and the environment by handing over your waste equipment to a designated collection point for the recycling of waste electrical and electronic equipment, appointed by the government or local authorities. Correct disposal and recycling will help prevent potential negative consequences to the nvironment and human health. Please contact the installer or local authorities for more information about the location as well as terms and conditions of such collection points.
Battery Directive – Information for Users
**** ‘In the European Union, this label indicates that the batteries in this
product should be collected separately and not be disposed of with household
waste. Substances in batteries can have a potential negative impact on health
and environment and you have a role in recycling waste batteries thus
contributing to the protection, preservation, and improvement of the quality
of the environment. You should contact your local authority or retailer for
details of the collection and recycling schemes.
EU Declaration of Conformity
Hereby, Shenzhen Yunmai Technology Co.,Ltd declares that the radio equipment
type YUNMAI X is in compliance with Directive 2014/53/EU. The full text of the
EU declaration of conformity is available at the following internet address:
www.yunmaiglobal.com
Simplify Your Workout
Discover a new world of sport with YUNMAI
Manufacturer : Shenzhen Yunmai Technology Co., Ltd.
Address : Room A, Floor 19, Chiwan Headquarters Building, NO.8 chiwan Sixth
Road,
Nanshan District, Shenzhen, China
Made in China
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>