tuztuala SE-1 3 In 1 Function Video Remote and Remote Shutter and Phone Holder User Manual

tuztuala SE-1 3 In 1 Function Video Remote and Remote Shutter and Phone

Holder

NOTE: About iPhone

About iPhone Special reminders for iPhone users:

Open the iPhone Settings – Accessibility Touch Assist Control is set to open state as shown below:

About iPhone until the following icon appears Special reminders for iPhone user: Open iPhone Settings- Accessibility Touch Assistive Touch, set to on See below:

Until the following icon appears

Package

Use Diagrams

Turn On

Press and hold the middle button for 1 second till the blue light turns on.

Turn Off

Press and hold the middle button for 5 seconds till the blue light flashes rapidly.

Pairing

In the off state, press and hold the middle for 1 second till the blue light flashes rapidly, and the controller is in a pairing state.

Connect mobile phone

Mode 1: Manually

In the off state, press and hold the middle for 1 second till the blue light flashes rapidly, the controller is in a pairing state, then turn on the Bluetooth of the mobile phone and search for the mobile phone, the Bluetooth menu shows: SE-1 and click to complete the Bluetooth connection. If you can’t find it, please try to turn off the mobile phone’s Bluetooth and turn it on again until the connection is completed.

Mode 2: Auto pairing

Turn on your mobile phone, the controller will automatically connect to the last mobile phone you connected to before (make sure the Bluetooth of the mobile is turned on).

Mobile Phone Stand

Take the bottom shelf slides out as a phone stand.

Button Function

Take Photos And Record Videos

In photo or video mode, press and hold any of these 2 keys will start or end and take pictures or video recordings.

Short press the middle button for focus.

Low battery warning

• Controller When the battery is low, the red light flashes slowly
• Charging box When the battery is low, the blue light flashes slowly

Charging Diagram

Charging Diagram

Automatic shutdown function

1. Normal pairing or disconnecting from the mobile phone to enter the pairing,lf the mobile phone is not connected within 5 minutes, it will automatically shut down.
2. If there is no operation after 30 minutes it will automatically shut down.

Parameter

FCC STATEMENT

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Information to user
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Information to the user

Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet the general RF exposure requirements. The device can be used in portable exposure conditions without restriction.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>