GARADOR Smart Phone Control Kit and App User Guide
- June 3, 2024
- Garador
Table of Contents
GARADOR Smart Phone Control Kit and App
The Smart Phone Control Kit works via your home’s WiFi network. Initial set up
involves linking your phone app, smart hub and device (e.g. garage door
opener) to your home network so that you can reliably operate your door from
the app.
This user guide will show you the steps required to get you started.
Before You Start
- Have your garage door opener or device operational & know your WiFi password.
- Place Smart Hub within range of your home WiFi router.
- Connect Smart Hub to power.
- Download the Garador App. (Scan one of the QR codes below.)
- Click on “Get Started” & follow the steps.
Download the App
Scan QR code to download the Garador App for iOS devices. garador.co.nz/ios/
Scan QR code to download the Garador App for android devices. garador.co.nz/android/
Smart Hub Setup Guide
Smart Phone App
-
Click on “Get Started”
-
Click on “Setup a new Smart Hub/Opener”
-
Click on “Smart Hub” then “Next”
-
Enable Hotspot – hold down the Hub button for 5 seconds, release when the LEDs flash, wait for the button to have a solid purple light. Click on “Next”
-
Click on “Allow Access to Location”
-
Click on “Next”
-
The hub will now connect to your phone app – press join
-
The button on the hub will now flash press it to continue
-
You are now connected
-
Setup the details on your device Click on “Next”
-
Complete your details
-
Enter your WiFi network details
-
Select your WiFi network – this needs to be a 2.4Ghz network
-
Enter your WiFi password and press ‘next’
-
The app will now connect to your WiFi this can take several minutes
-
Note: If your home has multiple WiFi networks and your phone reconnects to a different network to your hub you may see the above message
-
Searching for updates to the WiFi firmware, please wait
-
Firmware now updated, click on “Next”
-
Now you will need to link your opener or other device to the hub, click “+ Set up a new device”
-
Select Opener and press “Next”
-
Ensure your device is powered on and you have your registration code or QR card, Press “Next”
-
Select the hub that you wish to connect your opener to (If you have multiple hubs)
-
Click Scan QR Code or enter your registration code manually
-
If using a QR code press “OK” so that you can scan it
-
Scan your QR Code
-
Wait for it to connect your hub to your opener / device
-
You have now connected Press “Next”
-
Give your opener / device a name – i.e. Left Garage and press “Next”
-
Choose any notifications you want from the app and press “Done”
-
Set up complete – your smart opener is now ready to use. Press “Okay” to view your opener dashboard
0800 GARADOR (427 236) GARADOR.CO.NZ
STYLISH SMART AND SECURE SINCE 1962
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>