HINKLEY 1518CD-LL Atlantis Cedar Linear LED Path Light Instruction Manual
- June 3, 2024
- HINKLEY
Table of Contents
Installation Instructions
Family: Atlantis
Item No. **1518CD -LL**
1518CD-LL Atlantis Cedar Linear LED Path Light
Note: cedar finish requires different care. Please use the below
instructions for cedar maintenance. 
Cedar Maintenance for CD finish
Note: A thin clear coat, non-UV inhibiting lacquer was applied at the factory to minimize naturally occurring color change prior to installation. You may maintain the wood in any means typical for a cedar deck.
In order to maintain the cedar, remove the cedar from the fixture.
- Unscrew the two hex screws from the back of the fixture
- Slide the cedar up and off of the metal fixture.
Glass and Bulb Installation
- With a Phillips screw driver, remove flat head screw on the underside of the fixture.
- Remove the front plate.
- Insert the bulb into the socket.
- Slide the glass in the glass track at the back of the fixture.
- Once the glass is in place, re-assemble the front plate and screw.
Luminaire Mounting
(For typical ground spike mounting)
- To prevent electrical shock, disconnect the transformer from the electrical supply before installation or service.
- Run wire from luminaire through mounting hole in the top of the ground spike.
- Attach luminaire to ground spike by threading to mounting hole in spike and locking it in place.
- Place spike in desired position and insert into ground until the anger of spike is flush with ground.
- Strip the two wire leads from the luminaire and connect to the main supply wire using the provided silicone filled wire nut.
Note: Wire is to be protected by routing in close proximity to the luminaire or fitting or next to a building structure such as a house or deck. Wiring should be buried a maximum of 6 inches (15.2 cm) in order to connect to main supply wire. The main supply wire must have its length cut off within 6 inches (15.2 cm) from a building structure, a luminaire or fitting.
Bulb specifications
Power| 1.5W
Lumens| 150
Voltage| 12V/DC
CRI| 90+
Temperature| 2700 K
33000 Pin Oak Parkway
Avon Lake, OH 44012
(p)800.446.5539 / (f ) 440.653.5555
www.hinkley.com