LUXPRO LP1044 Rechargeable Pen Light User Manual
- June 3, 2024
- LUXPRO
Table of Contents
LUXPRO LP1044 Rechargeable Pen Light
Features
- Constructed with aircraft-grade aluminum
- LPE optics
- Push/pull focus beam
- Textured grip
- High quality pocket clip
- Tactical on/o button
- IPX4 waterproof rating
- Dual powered (USB or 2 AAA)
Product Warranty
The LP1044 has a Limited Lifetime Warranty Against Manufacturer’s Defects from
time of purchase.
For warranty claims please contact us by calling
801-553-8886 or sending an email to
info@simpleproducts.com
ANSI/PLATO FL1 STANDARD
MODES| LUMENS| RUN TIME| BEAM DISTANCE
10850 3.7V 750mAh Rechargeable Battery
High| 360 lm| 1h 30m| 70m
Low| 50 lm| 7h| 22m
2 AAA Batteries
High| 100 lm| 4h| 35m
Low| 12 lm| 12h| 12m
Operation Instructions
On/Off: Press and release the button on the tail cap to turn the light on
and off.
Cycle Modes: First turn the light on by pressing down the button on the tail cap completely and releasing. Half-press the button to cycle through modes (High/Low).
Light automatically resets to High mode when turned off.
Focus Head: To focus the light beam, gently push the head away from the
light to extend it. Pull the head back towards the light to widen the beam.
Charging Instructions
The charging port can be found beneath the sliding cover near the head of the penlight. Slide the cover towards the tail cap to reveal the charging port.
Using the USB-C charging cable included with the light, plug the small end of the charging cable into the port on the penlight. The larger end of the charging cable can be plugged into a USB wall adaptor.
The indicator light next to the charging port will turn red to indicate that it is charging. Once fully charged, the same light will turn blue. This light will not turn on while it is charging.
Replacement USB-C cables can be purchased at most big box retailers. We recommend using one that is 5 volts.
The LP1044 has a charge time of approximately 3 hours.
Battery Replacement
The LP1044 can also be used with 2 AAA alkaline batteries.
To use with 2 AAA batteries, turn the tail cap counterclockwise to remove it.
Tip the light downward to slide out the rechargeable battery. Store the
rechargeable battery in a cool, dry, and protected place. Insert both AAA
batteries into light (+) side first. Re-attach the tail cap by pressing down
lightly and turning it clockwise until tight.
If you know it will be a while between uses, we suggest removing the batteries from the flashlight and storing it in a dry, protected place.
luxpro.com 14725 S Porter Rockwell Blvd Ste C
866.553.8886 Bluffdale, UT 84065
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>