Sunco LED23WT5PLL LED 23W Pll Lamps Direct Wire Instructions

Sunco LED23WT5PLL LED 23W Pll Lamps Direct Wire Instructions

PLEASE FIND A QUALIFIED ELECTRICIAN FOR INSTALLATION

Please read the instructions before you install and use the luminaire

GENERAL

ALL ELECTRICAL CONNECTIONS MUST BE IN ACCORDANCE WITH LOCAL AND NATIONAL ELECTRICAL CODE (N.E.C.) STANDARDS. IF YOU ARE
UNFAMILIAR WITH PROPER ELECTRICAL WIRING CONNECTIONS OBTAIN THE SERVICES OF A QUALIFIED ELECTRICIAN. REMOVE THE TRIM FROM THE BOX AND MAKE SURE THAT NO PARTS ARE MISSING

• RISK OF SHOCK: DISCONNECT POWER BEFORE INSTALLATION

• WARNING – Risk of fire or electric shock. – Retrofit kit installation requires knowledge of electrical systems. If not qualified, do not attempt
  installation. Contact a qualified electrician.

• WARNING – Risk of fire or electric shock. – Install this kit only in the luminaires that have the construction features and dimensions shown in the photographs and/or drawings and where the input rating of the retrofit kit does not exceed the input rating of the luminaire.

• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.

• Installers should not disconnect existing wires from the lampholder terminals to make new connections at lampholder terminals. Instead installers should cut existing lampholder leads away from the lampholder and make new electrical connections to lampholder lead wires by employing application connectors.

• THIS RETROFIT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY
  AUTHORITIES HAVING JURISDICTION.

• This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

• The units covered in this report were intended to retrofit surface mount, Type IC or Non-IC recessed mount listed fluorescent luminaires that use a maximum of two lamps. The minimum dimensions of lamp compartment of luminaries are tabulated below.

ITEM#| BASE| MINIMUM LAMP COMPARTMENT DIMENSIONS| LAMP QTY
---|---|---|---
07219|

2G11

|

24”(L) x 23.6”(W) x 3.1”(H)

|

2

17219
27219

• TYPE B LAMP – intended for operation in luminaires with traditional fluorescent-type lampholders wired directly to the branch circuit. This includes both factory-wired luminaries as well as those converted for this purpose under a retrofit program.
  Only use the control provided with or specified by these instructions to control this lamp. This lamp will not operate properly when connected to a standard (incandescent) dimmer or dimming control. Dimmable only when used with special 0-10V system interface component, ETA Q1.

IMPORTANT SAFETY INSTRUCTIONS

• Product should be installed by a qualified electrician.
• Do not use LED driver with the product.
• The end retrofit luminaire has been modified and can no longer operate the originally intended lamp.
• Caution – Risk of Electric Shock – Use in Dry and Damp Locations Only.
• Not for use with totally enclosed fixtures.
• Risk of Electric shock – Do Not Use Where Directly Exposed To Water.
• This device is not intended for use with emergency exit fixtures or emergency exit lights.

WARNING – Disconnect power or circuit breaker before installing or servicing

RETROFIT LUMINAIRE WITH ONE LAMP

RETROFIT LUMINAIRE WITH TWO LAMPS

RETROFIT LUMINAIRE WITH THREE LAMPS Specifications subject to change without notice. Photos and line drawings may not be to scale and are for general reference only.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>