Razor PowerWing DLX Scooter Owner’s Manual
- June 3, 2024
- Razor
Table of Contents
Razor PowerWing DLX Scooter
Read and understand this entire manual before using this product! For assistance contact Razor. DO NOT RETURN TO THE STORE.
NOTE:
Manual illustrations are for demonstration purposes only. Illustrations may
not reflect exact appearance of actual product. Specifications subject to
change without notice.
Please have your product along with the 22-character product I.D. code with you before contacting Razor for warranty assistance and/or replacement parts. Product I.D. Code: _____ – ____ – ____
SAFETY WARNINGS
AN IMPORTANT MESSAGE TO PARENTS:
This manual contains many warnings and cautions concerning the consequences of
failing to maintain, inspect or properly use your PowerWing DLX. Because any
incident can result in serious injury or even death, we do not repeat the
warning of potential serious injury or death each time such a possibility is
mentioned.
WARNING:
Riding the PowerWing DLX can be a hazardous activity. Certain conditions may
cause the equipment to fail without fault of the manufacturer. Like other
wheeled products, the PowerWing DLX can and is intended to move, and it is
therefore possible to lose control, fall off and/or get into dangerous
situations that no amount of care, instruction or expertise can eliminate. If
such things occur, your child can be seriously injured or die, even when using
safety equipment and other precautions. USE
COMMON SENSE.
APPROPRIATE RIDER USE AND PARENTAL SUPERVISION
Direct adult supervision is required at all times. This manual contains
important safety information. It is your responsibility to review this
information and make sure that all children obey all warnings, cautions,
instructions and safety topics, and assure that young riders are able to
safely use this product. Razor recommends that you periodically review and
reinforce the information in this manual with young riders, and that you
inspect and maintain your children’s product to ensure their safety.
The recommended rider age of 6 years and older for the PowerWing DLX is only an estimate, and can be affected by the rider’s size, weight or ability. Any child unable to fit comfortably on the PowerWing DLX should not attempt to ride it. A parent’s decision to allow his or her child to ride this product should be based on the child’s maturity, skill and ability to follow rules. Do not exceed 143 lb (65 kg) on the PowerWing DLX.
Rider weight does not necessarily mean a child’s size is appropriate to fit or maintain control of the PowerWing DLX.
ACCEPTABLE RIDING PRACTICES AND CONDITIONS
Direct parental supervision is required. The PowerWing DLX is meant to be used
only in controlled environments, free of potential traffic hazards and not on
public streets. Do not allow your child to ride the PowerWing DLX in any areas
where vehicle traffic is present. Child must maintain a hold on the handlebars
at all times. Never allow more than one child at a time to ride the PowerWing
DLX. Never use near steps, sloped driveways, hills, roadways, alleys or
swimming pool areas. Do not ride the PowerWing DLX in wet weather.
The PowerWing DLX is intended for use on solid, flat, clean and dry surfaces, such as pavement or level ground, without loose debris such as rocks or gravel. Wet, slick or uneven and rough surfaces may impair traction and contribute to possible accidents. Do not ride the PowerWing DLX in mud, ice, puddles or water. Avoid excessive speeds that can be associated with downhill rides. Never risk damaging surfaces, such as carpet or flooring, by use of a PowerWing DLX indoors. Do not ride at night or when visibility is impaired.
PROPER RIDING ATTIRE
Always ensure child is wearing proper protective equipment, such as an
approved safety helmet. A helmet may be legally required by local law or
regulation in your area. A child should always wear shoes, never ride barefoot
or in sandals, and keep shoelaces tied and out of the way of the wheels.
WARNING:
ALWAYS INSPECT PowerWing DLX PRIOR TO RIDING. Properly inspecting and
maintaining your PowerWing DLX can reduce the risk of injury. Always inspect
your PowerWing DLX before riding and regularly maintain it.
WARNING:
CHECK LOCAL LAWS REGARDING PowerWing DLX USE. Check local laws and regulations
to see where and how you may use your Razor PowerWing DLX legally. In many
states and local areas, PowerWing DLX riders may be required BY LAW to wear a
helmet. Check local laws and regulations regarding laws governing helmet use
and PowerWing DLX operation in your area.
FAILURE TO USE COMMON SENSE AND HEED THE ABOVE WARNINGS INCREASES RISK OF SERIOUS INJURY. USE WITH APPROPRIATE CAUTION AND SERIOUS ATTENTION TO SAFE OPERATION.
BEFORE YOU BEGIN
Remove contents from box and check parts against part diagram below. Remove the separators that protect the components from damage during shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have occurred during shipping. Because the PowerWing DLX is partially assembled and packed at the factory, there should not be any problems even if the box has a few scars or dents.
Estimated Assembly and Set-Up Time
Allow up to 15–20 minutes for assembly. Razor recommends assembly by an
adult.
Required Tools
WARNING:
DO NOT USE NON-RAZOR PRODUCTS WITH YOUR PowerWing DLX. The PowerWing DLX has
been built to certain Razor design specifications. The original equipment
supplied at the time of sale was selected on the basis of its compatibility
with the frame, fork and all other parts. Certain aftermarket products may not
be compatible and will void the warranty.
Product ID Locations:
(See locations to the left)
- Side of Frame
- Box – Side of UPC (Not Shown)
Box Contents
- PowerWing DLX
- Allen Wrenches
- Owner’s Manual
ASSEMBLY AND SET-UP
Attaching the Platforms
Required Tools: Two (2) 5 mm Allen Wrenches (included)
- Using two (2) 5 mm Allen wrenches, remove the two (2) coupling bolts from the frame.
- Align the holes on the right and left platforms with the holes on the frame.
- Re-insert the coupling bolts and tighten using two (2) 5 mm Allen wrenches.
Attaching the Handlebars
Required Tool: 5 mm Allen Wrench (included)
-
Remove the plastic protector covering the wedge. Discard plastic protector.
-
Loosen the black folding knob, and swing to the 6 o’clock position to unfold the handlebar stem.
-
Insert the handlebar stem into the front fork. You may need to slightly loosen the wedge using a 5 mm Allen wrench to allow it to slip into the front fork. Note: Slide the handlebar stem down into the front fork until it fits snuggly into the lock nut on the headset.
Note: Make sure the front wheel is pointed straight ahead, the handlebars square to the front wheel and the Razor logo facing the front.
Note:
The cable and wire assembly from the handlebar must not wrap around the handlebar stem or handlebar. Sharp bends or twisting of the brake cable can cause the brake to malfunction. -
Using a 5 mm Allen wrench, tighten the stem bolt. The stem bolt is properly tightened when the handlebars cannot be twisted out of alignment with the front wheel.
-
Bring the handlebar stem back to the upright position.
-
Swing the black folding knob to the 12 o’clock position and tighten by hand until handlebars are secure.
Adjusting the Brake
- To adjust the brake cable wire, thread the brake lever adjuster in or out 1/4 to 1/2 turn until the desired cable tension is attained.
- Squeeze the brake lever to test the brake to make sure it is working properly. The front fender should clamp down and rub against the front wheel. If the brake is not working properly, proceed to the next step.
- If the brake is too tight or too loose, use a 8 mm wrench and a 3 mm Allen wrench to make adjustments as needed.
WARNING:
Failure to properly tighten the wedge may allow the handlebars to dislodge
while riding and may cause you to lose control and fall. When correctly
tightened, the handlebars will not rotate out of alignment with the front
wheel, under normal circumstances.
PRE-RIDE CHECKLIST
Loose Parts
Check and secure all fasteners before every ride. Make sure the steering bolts
and foot platforms are tight. There should not be any unusual rattles or
sounds from loose parts or broken components. If you are not sure, call
1-866-467-2967 for assistance.
Replacement Parts
Replace worn or broken parts immediately. Call
1-866-467-2967 for parts or visit
www.razor.com.
Brake
Check the brake for proper function. When you squeeze the brake lever, the
brake should provide positive braking action.
Frame, Fork and Handlebars
Check for cracks or broken connections. Although broken frames are rare, it is
possible for an aggressive rider to run into a curb or wall and wreck, bend or
break a frame. Get in the habit of inspecting yours regularly.
Safety Gear
Always wear proper protective equipment, such as an approved safety helmet,
elbow pads, and kneepads. Always wear shoes (lace-up with rubber soles) and
keep shoelaces tied and out of the way of the wheels. Never ride barefoot or
in sandals.
USAGE
How to Ride
Place both hands on the handlebars. Place one foot on the platform directly
above the caster. Push off with the other foot then place a foot on the other
platform directly above the caster. Slightly bend your knees. With handlebars
straight, swing hips and legs side to side. Shifting weight on the platforms
from right to left in sync with hips and legs. The side-to-side motion acts to
self-propel the PowerWing DLX. No pushing is required.
How to Stop
Apply the hand brake by squeezing the brake lever.
Note:
Do not step off of platforms until unit has come to a complete stop.
POWERING DLX PARTS
Keep your PowerWing DLX working for years with genuine Razor parts. Visit our website www.razor.com to purchase replacement parts. (Specifications subject to change without notice.)
- Handlebar Stem
- Handlebar Grip (x2)
- Handlebar End Caps (x2)
- Brake Lever Assembly
- Quick-Release Lever
- Black Folding Knob
- Wedge
- Stem Bolt
- Headset
- Front Wheel
- Front Fork with Fender Assembly
- Platform (Right/Left)
- Deck Protector (x2)
- Platform Coupling Bolt (x2)
- Stability Bar (Right/Left)
- Caster (Right/Left)
- 64 mm Rear Wheel (Right/Left)
WARRANTY
Razor Limited Warranty
The manufacturer warrants this product to be free of manufacturing defects for
a period of 6 months from the date of purchase. This Limited Warranty does not
cover normal wear and tear, wheels, or any damage, failure or loss caused by
improper assembly, maintenance, storage or use of the Razor PowerWing DLX.
This Limited Warranty will be void if the product is ever:
- used in a manner other than for recreation or transportation;
- modified in any way;
- rented.
The manufacturer is not liable for incidental or consequential loss or damage due directly or indirectly to the use of this product. Razor does not offer an extended warranty. If you have purchased an extended warranty, it must be honored by the store at which it was purchased. For your records, save your original sales receipt with this manual and write the serial number below.
CUSTOMER SERVICE CONTACT INFORMATION
Need Help?
Visit our website for product support, a list of authorized service centers in
the US and customer service contact information at
www.razor.com. Please have the product I.D. code
(located on the white label of your product) available for better assistance.
Additional Customer Service contact information is listed below:
AMERICAS
Razor USA LLC P.O. Box 3610 Cerritos, CA 90703 USA
+1 866 467 2967
Monday – Friday
8:00 AM – 5:00 PM Pacific Time
customersupport@razorusa.com
UNITED KINGDOM AND IRELAND
Razor USA LLC (UK)
Unit 20 Hartnoll Business Centre Post Hill, Tiverton Devon EX16 4NG UK
+44 (0) 120 267 2702
info@razoreu.com
EUROPE, MIDDLE EAST, AFRICA
Razor USA LLC (Europe) Handelsweg 2 2742 RD Waddinxveen Netherlands
+44 (0) 120 267 2702
info@razoreu.com
AUSTRALIA AND NEW ZEALAND
Razor USA LLC
P.O. Box 4280 Auburn South VIC 3122 Australia
+1 800 954 354 (AU)
+0 800 003 221 (NZ)
info@razoranz.com
ASIA
Razor USA LLC (Asia)
P.O. Box 3610 Cerritos, CA 90703 USA
+81 50 7579 6622
info@razor-asia.com.
US Patent No. 7,597,334 B2, 7,681,895 B2 & 7,784,803 B2
Printed in China for Razor USA LLC.
Copyright © 2003-2021 Razor USA LLC. All rights reserved. Razor®, PowerWing®
and the Razor logo design are among registered trademarks of Razor USA LLC in
the United States and/or select foreign countries.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>