PowerFilm Solar Image Power Film Plus Scanner User Manual
- June 3, 2024
- PowerFilm SOLAR
Table of Contents
PowerFilm Solar Image Power Film Plus Scanner
Unpacking and How to insert the film feed holder
Unpack contents and remove protective tape.
Contents:
Power Film Scanner, film feeder, universal adapter with interchangeable plug
(US/EU/UK),USB 2.0 cable.
If any items are missing, please contact your nearest dealer or place of
purchase
Please be sure the film feeders inserted properly and secure before
proceeding.
Software installation
A DO NOT CONNECT the scanner before installing the software.
If you see a “Found New Hardware” screen, click “Cancel” and disconnect the
scanner.
B Please download the software from https://www.scanace.com
Double-click the software program to finish installation.
C After installing the software, locate the power switch on the lower right rear side of the scanner. Make sure the scanners TURNED OFF. Plug the AC adapter into an AC power source FIRST before plugging it into the scanner. Then switch power to the “ON” position.
Organizing your filmstrips
Sort your filmstrips by type—keeping color negatives, color positives and B&W
filmstrips in separate batches. You can only scan films of the same type in
each session, DO NOTMIX.
You can scan 1-10 filmstrips at a time, of 2-6 frames in length. Please note
Power Film cannot process individual frames. when inserting, film strips
should be placed with the emulsion (dull) side facing down.
Cleaning and checking your filmstrips
If films have not been stored in the plastic sleeve from developer, orifthereis dust on them, please clean using a soft lint free cloth and isopropyl alcohol (concentration of 98% or greater)
Please only insert filmstrips that are in good condition. Do not use film that
is warped, stained, crumpled, curled up or damaged in any way.
Follow us on Facebook
https://www.facebook.com/Pacific-Image-Electronics-395587123830570/
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>