Vornado Glide Heat Glide Vortex Heater User Manual
- June 3, 2024
- Vornado
Table of Contents
Vornado Glide Heat Glide Vortex Heater
Specifications
- SPECIAL FEATURE: Advanced Safety Features
- COLOR: Black
- INDOOR/OUTDOOR USAGE: Indoor
- POWER SOURCE: Corded Electric, Wood
- HEATING METHOD: Forced Air
- ITEM WEIGHT: 5 Pounds
- HEAT OUTPUT: 1500 Watts
- PRODUCT DIMENSIONS: 2″D x 8.2″W x 9.4″H
Introduction
The Glide is likely to stand out in your home with its contemporary steel base and natural hardwood feet. For individualized comfort, the adjustable axis tilts 20 degrees. When you combine that with Vornado’s effective vortex circulation, your space will stay sultry and fashionable no matter how cold it gets outside. To ensure worry-free use, this entire room heater is outfitted with cutting-edge safety features, such as a tip-over switch that instantly turns off the heat and power if the device tips over. The Glide’s distinctive design by Vornado ensures that it stays cool to the touch even after prolonged use. Additionally, the Glide comes with a 5-year limited warranty to ensure worry-free warmth season after season.
SAFETY FEATURES
CONTROLS
HOW TO USE
Before use, check appliance for visible damage. DO NOT USE THIS HEATER if there is evidence of damage. If any damage is found, contact Vornado Air LLC at 1-800-234-0604.
- Position heater so airflow is not obstructed.
- Plug power cord into standard grounded wall outlet.
- GLIDE HEAT has an adjustable axis to direct the airflow where you want it. Adjust the tilt up to 20 degrees by sliding the easy-to-adjust head.
- The heater has rear-mounted controls. Use the toggle switch to select Low Heat or High Heat. Red power indicator light located on front of heater (at top of the heater inserted between the grill and housing) illuminates to indicate the heater is On. Set thermostat knob to highest setting by turning clockwise. When room reaches desired comfort level, turn thermostat knob slowly counterclockwise until heat cycles off.
- If heater tips over, power will be cut to the heater. The red indicator light will not illuminate until you position the heater back in upright position and power is restored.
CLEANING
Because your heater moves a substantial amount of air, it will need regular cleaning. Cleaning the outside of the heater is recommended on a weekly basis. If service is required, return your heater to Vornado. (See WARRANTY for instructions.)
- Unplug heater before cleaning.
- Use brush attachment on household vacuum cleaner to vacuum any accumulated dust-off Air Inlets on the back of heater.
You should periodically blow out the heater with pressurized air to keep heat element and motor clear of dust, hair and debris that can build up inside the heater as it moves air during use. This also eliminates unwanted odors caused by accumulation of these particles inside the unit.
- Use brush attachment on household vacuum cleaner to vacuum any accumulated dust-off Front Outlet Grill.
- Wipe down entire heater with a soft, dry cloth.
NOTE: Do not modify this product with any aftermarket accessory.
STORAGE
During the off-season or after extended periods of non-use, you may choose to store your heater. To ensure long life of the product, it is recommended to store your heater by following these instructions:
Cleaning is recommended before storage.
- Unplug power cord and bundle loosely.
- Cover, or place back in retail carton if available. This prevents heater from accumulating dust over time.
- Store heater in cool and dry location.
RESET HEATER
RESETTING YOUR VORNADO HEATER
Your Vornado Heater has a multilevel safety shut-off system designed to prevent overheating. Overheating may occur when the inlets or outlet are blocked. If this happens, the safety shut-off system cuts power to the heater and you must manually reset the heater.
- Power heater off, then unplug power cord.
- Remove any obstructions.
- Wait 5–10 minutes, allowing heater to cool down.
- Plug in power cord and place heater in desired position.
- Power heater On. Your Vornado Heater should now function normally.
Note: If the safety shut-off system repeatedly shuts off your heater or if it will not reset after following the above procedure, call Vornado Consumer Services Department toll-free at 1-800-234-0604.
TROUBLESHOOTING
Unit fails to power on.
| |
Unit is not plugged in. Plug power cord into electrical outlet.
Household circuit breaker / ground fault circuit interrupter has tripped or blown fuse. Reset circuit breaker
/ ground fault circuit interrupter, or replace fuse. See IMPORTANT INSTRUCTIONS. Unit has overheated. Automatic Safety Shut Off has initiated. See RESET HEATER.
Internal tip-over switch has been tripped and safety shut-off system has cut power to heater. Place heater
on level surface. See SAFETY FEATURES.
Unit is damaged or in need of repair. Cease usage and unplug. Contact Consumer Service for assistance.
---|---|---
Unit is not producing sufficient amount of heat.| | Ensure unit is set
to High Heat and thermostat is set to highest temperature setting. Close all
doors and windows to trap heat.
Allow unit to fully circulate heat throughout room; may take several minutes.
FAQs
When the temperature reaches the thermostat setting, does the fan stop running or does the fan keep running and just the heating element shut down?****
When the temperature reaches the set temperature, both heat and fan stop running.
Is there a remote control?****
No , there is no remote.
Does the grille stay cool to the touch when unit is running?****
No. It’s not insulated so heat escapes much like any other grill.
Does it has a Timer?****
The Glide heater does not have a timer.
Is the grill metal or plastic?****
Grill is metal. Body is plastic. Would not purchase again. Blows my breaker every time I use it. No matter what circuit. My other Vornado doesn’t do this.
How many square feet will this keep warm?****
Up to 256 square feet enclosed.
Can this also act as just a fan (with no heat)?****
You can lower the thermostat. But not really a regular fan.
Will this product function as a circulating fan without heat?****
No, if the fan is running, it is producing heat.
Does it give off a bad smell when used for the first time? If so, how long does the smell last?****
It’s not a “bad “smell… it smells like a new electrical product being used for the first few times. The odor goes away after that.
Where is this item shipped from?****
I no longer have receipts but recall that it arrived from the Midwest.
Is this product suitable for European voltage 240 too? and will it work with an adapter?****
No.
Is it ceramic?****
This unit is nor ceramic.
Is it made in U.S?****
This unit is not made in the US.
what size room is this suitable for???****
I’ve used it comfortably in a medium sized room about 22 x 14 and in a smaller room about 1/3 this size.
Does it contain tungsten?****
No.
Video
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>