relaxn Solar Smart Sensor LED Wall Ligth User Manual

relaxn Solar Smart Sensor LED Wall Ligth

SPECIFICATIONS

FEATURES

• Patent “V” shape double side light design: front lighting cool white (6000K) / back lighting warm white (3000K).
• Lumen output of up to 220Im.
• 120° wide angle PIR sensor detects up to 6 meters away.
• Lasts up to 2-4 nights from a single 5-6 hour charge.
• Easy to install, no wire, no running power cables, just fit and forget.
• Rated IP65 water and dust protection.
• Mounting screws included.

ACCESSORIES

• l x Solar Smart Sensor LED Wall Light
• Mounting Screws
• User Manual
• Mounting Template

NOTICE

1. The lamp button is a power-off switch, the lamp can get solar charged in any mode.
2. This is a solar powered lamp, please install it in a location where it can get enough sunshine.
3. Please note the lighting time depends on the sunshine duration & weather.
4. Built-in intelligent IC with over-charge, over-discharge and over-voltage protection.
5. The lamp gets solar charged in the daytime, and lights up automatically at dusk.
6. The lamp is equipped with an internal battery pack, which is replaceable. If required, please contact the seller for the correct new battery pack.
7. Non-professionals please do not disassemble the lamp.
8. Please do not dispose of the battery with household garbage to avoid explosion.

WORKING MODES

• Button Control:
• Please press the button on the lamp to select working modes.
• Press 1st time for Mode A;
• Press 2″‘ time for Mode B;
• Press 3″ time for off
  

Mode A

The lamp will automatically turn on l 00% full brightness when the sensor has detected motion in the 6 meter radius and then turns to lower brightness (front & back lights on) after l O seconds of no motion.

Mode B

The lamp will automatically turn on l 00% full brightness when the sensor has detected motion in the 6 meter radius and then turns to lower brightness (front & back lights on) after l O seconds of no motion.

INSTALLATIONS

1. Use the included mounting template to mark the holes position and drill 2 holes of 06mm with a hole distance of 120mm on the wall.
2. Fix the expansion plugs in the holes.
3. Fit the screws into the expansion plugs, and allow the screws to protrude slightly around4mm.
4. Hang the lamp on the screws to fix the lamp on the wall.
5. Turn on the lamp and set desired working mode.

WARRANTY

Sam Allen Wholesale warrants this product against defects in manufacture and workmanship for a period of l year from the date of purchase. This warranty is only valid for products installed and operated within the guidelines specified by Sam Allen Wholesale, and within the correct operating voltage ranges as stated on the product’s rating label.
Warranty does not include damage or loss arising from incorrect installation, operation or maintenance of this product, damage caused through modification, service by unqualified or unauthorized personnel or lack of regular maintenance and cleaning. Proof of installation by qualified personnel may be required.
This warranty is provided in addition to any other rights and remedies of the customer under any law. In applications not intended for household, personal or domestic use, liability is limited to replacement or reimbursement of the product only. Sam Allen Wholesale does not warrant the costs of removal or re- installation of this product or associated components.
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. The consumer is entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if goods fail to be of acceptable quality and the failure does not amount to a major failure.
To make a claim under the warranty: Please return to the point of purchase, including reasonable proof of that purchase.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>