MOB KC8282 Reflective Armband User Manual
- June 3, 2024
- MOB
Table of Contents
MOB KC8282 Reflective Armband
Hereby, MOB, declares that item KC8282-14 square pattern. IS in Compliance with the essential requirements and other relevant conditions of regulation: (EU)2016/425. The full text of the EU declaration of conformity is available at the following internet address: www.momanual.com.
Description
Reflective wrist strap for non-professional use.
Standard compliance
17353:2020 certified by Eurofins Textile & Testing Spain
Notified Body number: 2865
Type B2: for night conditions
17353:2020
Color: Silver
Material
- Outside layer: 100% Polyvinyl chloride
- Inside: 100% Carbon Steel
Size
One size
- Width (mm): 30
- Length (mm): 320
Care Instructions
- Hand wash only
- Do not bleach
- Do not tumble dry
- Do not iron
- Do not dry clean
Use
Visibility bands are intended to signal the user’s presence visually when illuminated by vehicles on dark roads. These products are useful because the movement and reflective features attract the attention of the observer.
Attachment method
If you want to use the reflective wrist strap, attach it to your wrist / ankle or to the part you want to mark with the reflective surface upwards, firmly hold one reflective end and bend the second end until the band snaps together. To straighten it, loosen it and pull it until a “cracking” sound is heard – the band returns to its original position.
Inappropriate use
The bands should not contact with liquid chemicals, especially solvents, and fire. Excessive mechanical damage (tearing, ripping, etc.) must also be avoided. Products must not be damaged or destroyed during transport.
CAUTION
Lifetime of the removable belt. This product must be kept clean in order to
remain functional. Immediately replace it if it is permanently dirty or faded.
Use restrictions: To provide the correct protection as stated above, the
band must be worn over the outer garment and must not be covered.
Storage
Do not store in direct sunlight. Store in a closed, dry storage area, protected from heat from radiators, store at least 1 m from a radiator. If the band gets wet, wipe it with a soft cloth and let it dry at room temperature and then store it.
Maintenance
The reflective band can be cleaned by hand, with a soft cloth, sponge or soft brush. After cleaning the band, rinse it with clean water, wipe it with a soft cloth and let it completely dry. Never wash the product in a washing machine, do not use chemicals to clean, iron or dry in a tumble dryer or near a radiator.
Keep this information leaflet safe.
WARNING: If the product is used, stored, or handled otherwise than as described, its function may be impaired or altered. At least two straps shall be used to achieve 360° visibility; these shall be used on the left and right side of the wrist/ankle.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>