sycamoreLED SY7786 Slimline Infra Red Sensor Cabinet Light Instruction Manual

sycamoreLED SY7786 Slimline Infra Red Sensor Cabinet Light

Thank you for purchasing this SycamoreLED.com product. Please make sure instructions are followed carefully prior to and during installation and the product is not altered, otherwise, a warranty may not be valid. For technical support or warranty information please visit www.sycamoreLED.com, or call our dedicated technical helpline at +44 (0) 113 2866686.

IMPORTANT—Please read prior to installation

1. Please read these instructions carefully before commencing any work.
2. This product must be installed by a qualified electrician in accordance with the current IEE wiring regulations.
3. To prevent electrocution switch the power off at the mains supply before installing or maintaining this fitting.
4. Ensure others cannot restore the electrical supply without your knowledge.
5. The PSU must be rated 12VDC and be compatible with the pre-wired connector system of this product
6. Never exceed the wattage stated.

DIAGRAM

INSTALLATION

1. Isolate the electricity supply before carrying out any electrical work.
2. Position a suitable 12V-rated driver in a suitable location where it will not be subject to moisture or dampness
3. Decide the position of each light, ensuring the fittings can be linked to the driver via the plug-in connector system
4. The position of each light must be able to detect the movement of a door (s)
5. Route cable in the desired location to allow plug-in connection to the driver
6. Remove the front cover and use the screws supplied to fit the base unit to the carcass
7. Clip on the front cover
8. Plug in each fitting to the driver
9. Connect the primary side (240v) of the driver to a suitable power supply
10. Restore power and check the operation of the lighting.

CARE IN USE

1. Please note this fitting has non-replaceable parts
2. Always switch off or disconnect from the mains when cleaning the product.
3. We recommend cleaning with a soft dry cloth. Do not use scourers, abrasives, or chemical cleaners.

SycamoreLED.com
LS26 8XT

Technical helpline: 0113 2866686

Please email sales@sycamoreled.com to register your product.

References

• Home Page - Sycamore Lighting Ltd
• Home Page - Sycamore Lighting Ltd

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>