sycamoreLED com SY8935 Sirius Magnetic Super Slim Cabinet Light Instruction Manual
- June 3, 2024
- sycamoreLED com
Table of Contents
SY8935 Sirius Magnetic Super Slim Cabinet Light
Instruction Manual
SY8935 Sirius Magnetic Super Slim Cabinet Light
Installation instructions: Sirius Magnetic Super Slim Cabinet Light
SY8935
Thank you for purchasing this SycamoreLED.com product. Please make sure
instructions are followed carefully prior to and during installation and the
product is not altered, otherwise, a warranty may not be valid. For technical
support or warranty information please visit
www.sycamoreLED.com, or call our dedicated
technical helpline at +44 (0) 113 2866686.
IMPORTANT—Please read prior to installation
- Please read these instructions carefully before commencing any work
- Please retain this leaflet for future reference
- To be used only with listed class 2 power supplies.
- Always consider the voltage drop effect when linking fixtures together.
- To extend the driver life span, do not exceed 80% of the driver-rated load.
DIAGRAMS SPECIFICATION
INSTALLATION
- Open the packaging and place all components onto a clean surface.
- Turn the power OFF from the electrical panel before starting installation.
- A) For surface mounting: Remove the trim ring from the puck light and lift the LED light out of the surface mounting ring (without completely removing the wire). Position the mounting ring in the desired location. Ensure the wire for the LED puck light is positioned in the wire groove of the surface mounting ring. Attach the surface mounting ring to medium using the screws provided. Pull the excess wire through the wire notch, then re-attach the LED light to the surface mounting ring. Connect the trim ring to the LED puck light magnet tabs. Attach wire evenly to the surface medium with mounting hardware. B) For recessed mounting: Remove the trim ring from the puck light and remove the LED light completely from the surface mounting ring. With a screwdriver detach the torsion clips from the LED puck light. In your desired area drill a 2-1/4″ hole, using a cut hole saw (supplied by others). Run the wires through the cut hole, and then secure the LED puck light to medium with the screws provided. Connect the trim ring back to the LED puck light magnetic tabs.
- Place the driver in a desired secured location.
- Once assembly is complete, turn on the power to confirm the fixture is working properly.
CARE IN USE
- Please note this fitting has nonreplaceable parts
- Always switch off or disconnect from the mains when cleaning the product.
- We recommend cleaning with a soft dry cloth. Do not use scourers, abrasives, or chemical cleaners.
- For your safety, this fixture must be wired in accordance with local electrical codes and ordinances. All work should be done by a qualified electrician.
SycamoreLED.com
LS26 8XT
Technical helpline: 0113 2866686
*Please email sales@sycamoreled.com to
register your product
Documents / Resources
|
sycamoreLED com SY8935 Sirius Magnetic Super Slim Cabinet
Light
[pdf] Instruction Manual
SY8935 Sirius Magnetic Super Slim Cabinet Light, SY8935, Sirius Magnetic Super
Slim Cabinet Light, Sirius Magnetic Cabinet Light, Magnetic Super Slim Cabinet
Light, Super Slim Cabinet Light, Slim Cabinet Light, Cabinet Light, Magnetic
Cabinet Light, Sirius Cabinet Light
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>