Rindustries RFB-1110-C-04 Coax Connector Installation Guide
- June 13, 2024
- Rindustries
Table of Contents
CABLE ASSEMBLY INSTRUCTIONS
RFB-1701-D
RFB-1110-C-04 Coax Connector
Step 1: Cut end of cable evenly. Strip cable to dimensions shown in
catalog or on outline drawing. All cuts are to be clean and square. Do not
nick braid or center conductor when cutting. Slide back nut, washer and gasket
onto cable. Comb braid for assembly of clamp.
Step 2: Slide the clamp over cable braid and under cable jacket. Push
clamp back against cable jacket. Fold back braid wire and form over the clamp
evenly. Trim extra braid if needed. Slide gasket, washer and back nut close to
the clamp.
Step 3: Insert cable assemble into main body. Tighten back nut while
holding body stationary.
Step 4 : Solder cable center conductor to pin using minimum amount of
heat. Cable center conductor should not extend past outer diameter of
connector pin. Tighten “screw cap” with flat head screw driver.
RFB-1110—C-04 AP.DWG
RF CONNECTORS
7610 Miramar Road, San Diego, CA 92126-4202 —
858-549-6340
800-233-1728 — Fax
858-549-6345 E—mail:
rfi@rfindustries.com —
www.rfindustries.com
1/23/06
CZ
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>