EATON IL019001EN Air Circuit BREAKER Instruction Manual
- June 3, 2024
- EATON
Table of Contents
EATON IL019001EN Air Circuit BREAKER
This
document illustrates the proper installation of the adapter for remote
mounting of the Series NRX CAM module.
Kit Contents.
| Qty | Item |
|---|---|
| 1 | Adapter Harness – CAM module to NRX Breaker Secondary |
| 1 | Ferrule 2-18AWG (Weidmuller PN 9004310000) |
| 1 | Installation Instructions |
This kit does not include the DIN rail for mounting the CAM module.
This kit provides an additional cable adapter for connection from the
Communications Adapter Module (CAM) to the circuit breaker when the CAM needs
to be mounted remotely such as with a Fixed Mount circuit breaker .
Connection of Adapter Cable to the NRX Circuit Breaker.
The adapter consists of a 1 meter (3 ft.) length of cable that connects
between the CAM module and the breaker secondary. The CAM module should be
mounted on a length of standard grounded DIN rail.
The numbered flags on each wire of the cable directly correspond with the
breaker secondary terminal designators. When connecting the adapter to the CAM
module, ensure Pin 19 (as indicated by the numbered flags), is positioned in
the lower left as indicated in .
Connection to the CAM Module.
Note that the CAM module connector is keyed to fit in only one direction.
Installation Instructions for the Series NRX Breaker and Trip Unit Remote
Mount CAM Module Adapter
The drain wire may be connected to the SHIELD terminal on the MCAM or the ICAM. Or it may be connected to the grounded DIN rail. If a PCAM or ECAM module is used use the 2-18 AWG Ferrule provided to connect the cable drain wire for a proper connection to the power supply ground terminal as shown in . Connection to the CAM Module.
Documents / Resources
|
EATON IL019001EN Air Circuit
BREAKER
[pdf] Instruction Manual
IL019001EN Air Circuit BREAKER, IL019001EN, Air Circuit BREAKER, Circuit
BREAKER, BREAKER
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>