AdeptAudio IO50W Indoor Outdoor Speakers User Guide
- June 3, 2024
- AdeptAudio
Table of Contents
AdeptAudio IO50W Indoor Outdoor Speakers
Connecting the Speaker Cables
To connect a speaker cable, first strip ½ inch of insulation from each conductor of the cable, and lightly twist the exposed strands between your fingers to make sure there are no stray strands sticking out. Be sure to connect the positive half of the cable (usually marked with a line on the side, or sometimes with red or white insulating jacket) to the positive speaker cable connector, which is marked with a red dot. Unscrew each speaker cable binding post until you see the hole in the post’s center shaft. Put the stripped end of the wire through the hole, making sure the bare wire contacts the metal post, and tighten the binding post. Give the cable a light tug to make sure it’s firmly connected.
Repeat with the other half of the cable. Make sure there are no stray strands
of wire that might contact the other half of the speaker wire and create a
short circuit.
You may also choose to crimp spade lug or banana plug connectors onto the
cable. If you use spade lugs, unscrew the posts a few turns, insert the
spades, and tighten the post down. If you use banana plugs, simply remove the
plastic covers at the ends of the binding posts and insert the plugs into the
holes in the ends of the binding posts. Be sure to connect the positive
conductor to the red binding post, and the negative conductor to the black
binding post.
Specifications
IO50B, IO50W
5 ¼” Injection-Molded Polypropylene (IMPP) Woofers 1” Pivoting Aluminum-Dome
Tweeters
Power Handling: 75 Watts
Frequency Response: 55Hz-20kHz
Impedance: 8 ohm
Sensitivity: 89dB, 1W/1m
Dimensions: 7 ½” x 8 3/8” x 10 5/8” (191 x 213 x 270mm)
IO80B, IO80W
- 8” Injection-Molded Polypropylene (IMPP) Woofers 3”
- Injection-Molded Polypropylene (IMPP) Midrange 1”
- Pivoting Aluminum-Dome Tweeters
- Power Handling: 150 Watts
- Frequency Response: 39Hz-20kHz
- Impedance: 4 ohm
- Taps: 70V – 60W/30W/15W/7.5W
- 100V – 60W/30W/15W
- Sensitivity: 91dB, 1W/1m
- Dimensions: 10” x 10 ¾” x 15” (253 x 273 x 381mm)
IO60B, IO60W
- 6 ½” Injection-Molded Polypropylene (IMPP) Woofers 1”
- Pivoting Aluminum-Dome Tweeters
- Power Handling: 100 Watts
- Frequency Response: 45Hz-20kHz
- Impedance: 8 ohm
- Sensitivity: 90dB, 1W/1m
- Dimensions: 8 7/8” x 9 ½” x 12 ½” (224 x 240 x 317mm)
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>