LUXPRO LP323 Multi Color LED Headlamp User Manual
- June 3, 2024
- LUXPRO
Table of Contents
LUXPRO LP323 Multi Color LED Headlamp
Features
- Durable ABS and rubberized compact design
- LPE optics, Multi-color COB LED area light
- Dual button intuitive mode selection
- Non-slip adjustable headband
- IPX4 waterproof rating
- Batteries included (3 AAA)
Product Warranty
The LP323 has a Limited 1-Year Warranty Against Manufacturer’s Defects from
time of purchase.
For warranty claims please contact us by calling
801-553-8886 or sending an email to
[email protected]
ANSI/PLATO FL1 STANDARD
MODES|
LUMENS RUN TIME
| BEAM DISTANCE
---|---|---
High+
| Spot Modes
300 lm 3h
|
85m
High Spot| 220 lm 4h| 40m
Low Spot| 50 lm 6h
Flood Modes
| 20m
High White| 85 lm 5h 30m| 20m
Low White| 34 lm 8h 30m| 5m
Green| 51 lm 7h 30m| 5m
Red| 15 lm 3h| 1m
Operation Instructions
Spot On/Off & Cycle Modes: Press and release the button on the right of
the headlamp to turn spotlight on. Press button repeatedly to cycle through
modes (Spot High/Spot Low).
High+ Mode: Press and hold the right button for 2 seconds to turn on
High+ Mode. Flood On/Off & Cycle Modes: Press and release the button on
the left of the headlamp to turn flood light on. Press button repeatedly to
cycle through modes (High White/LowWhite/Green/Red).
Strobe: From any mode, press and hold the left button for 2 seconds to
switch to Strobe mode.
Battery Replacement
The LP323 uses 3 AAA batteries.
To replace the batteries, first locate the two plastic tabs on the sides of
the headlamp. Gently push tabs outward using both thumbs to separate the
battery cover from the main headlamp housing. Remove the old batteries and
insert new batteries according to the (+/-) symbols in the battery tubes. For
best results, we recommend using brand new alkaline batteries that are the
same voltage and brand.
To re-attach the battery cover, line the plastic tabs on the main housing up
to the battery cover taking note to match them in proper orientation (the
LUXPRO logo on the battery cover should line up with the On/Off buttons on the
main housing).
Gently press the two sides together until they click into place. Check that
the battery cover is secured by gently tugging on the headlamp straps while
holding the main housing firm.
If you know it will be a while between uses, we suggest removing the batteries from the head lamp and storing it in a dry, protected place.
Website: luxpro.com
Tel: 866.553.8886
Address: 14725 S Porter Rockwell Blvd Ste C Bluffdale, UT 84065