hager XEVA130 One Charging Station Circular Pedestral Instruction Manual
- June 3, 2024
- hager
Table of Contents
**hager XEVA130 One Charging Station Circular Pedestral
**
DIMENSION
PACKAGE CONTENT
TOOLS REQUIRD
INSTALLTION
| Before you install the post, make sure that all the necessary cables and
conduits have been run from the cabinet to the terminal.
---|---
-
Location requirements
-
Assembling the embedded base
-
Sealing the embedded base
| If installed without the embedded base, use the drilling template on page
13. If chemical sealing is employed, Ø 12 mm threaded rods should be used
---|---
- Place all the cables inside the post and pass them through their respective holes.
- Fix the post to the ground using the nuts.
Fitting the earthing cables
| Equipotential bonding must be run between the terminal, the post and the
support.
---|---
Installing pedestals
Follow the instructions given in the “Opening” chapter of the manual provided with the terminal. Then follow the steps described below.
Technical features
X EVA1 30 / X EVA1 35 : posts to in s t a ll oectesta l s
Weight| 7,8 kq
Dimensions (D x H)| 200 x 1300 mm
Earth wire length| 1,2 m
Earth wire cross-sectional area| 16 mm2
Operating temperature| -25°C a +55 °C
Storage temperature| -25 °C a +70 °C
Colour| RAL 7021
Finish| matt paint
X EVA 1 1 6 : earthen kit
Weight| 5 kg
Earth cable length| 10m
Earth cable cross-sectional area| 50 mm2
Operating temperature| -25°C a +55 °C
Storage temperature| -25°C a+70 °C
X EVA1 50 : e m bedded base
Weight| 3,6 kg
Dimensions (L x H x D)| 400 x 700 x 108 mm
Operating temperature| -25°C a +55 °C
Storage ae temperature| -25°C a+70°C
| Please refer to the relevant instructions when installing the charging
terminal.
---|---
| This document is not contractually binding and is subject to change without
notice
---|---
Drilling template
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>