PHILIPS BDS490 CityCharm Cordoba lighting User Manual
- June 3, 2024
- Philips
Table of Contents
PHILIPS BDS490 CityCharm Cordoba lighting User Manual
Annex I: Simplified EU Declaration of Conformity
Hereby, Signify Holding declares that the radio equipment type included into the luminary is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: http://www.philips.com/lighting
Signify Holding
Hereby, declares that the radio equipment type is in compliance with
Directive 2014/53/EU. The full text of the EU declaration of conformity is
available at the following internet address:
http://www.philips.com/lighting
01/2020
Signify
I.B.R.S. / C.C.R.I. Numero 10461
5600 VB Eindhoven, the Netherlands
00800-74454775
Disconnect before servicing
Luminaire has basic insulation between Low Voltage supply and control conductors
The light source contained in this luminaire and the external flexible cable shall only be replaced by the manufacturer or his service agent or a similar qualified person.
⚠ Storage, installation, use, operation and maintenance of the products needs to be performed exactly according the instructions in this manual and/or other instructions as may be provided by us to guarantee safe use of the product over its entire lifetime. Failure to adhere to these instructions will invalidate your entitlement to warranty. Bolts with indication of torque strength on the drawing need to be tightened using a calibrated torque wrench. Pre-assembled bolts need to be retightened again to the required torque specification to assure maximum strength over lifetime.
⚠ SR compatibility – For SR-based luminaires only SR-Certified components/sensors are to be used (see also: http://www.lighting.philips.co.uk/oememea/products/driving-connected- lighting). The functional compatibility of two (SR-certified) components/sensors to be used in combination, as well as the override possibility of any line-switch function used in an SR-based luminaire, is to be released by the master component/sensor supplier. If using a NEMA 7- pin socket on an SR-based luminaire, a full system verification is required. Not following this advice can/will cause risk of damage and non-compliance for which Signify cannot take any responsibility.
© 2020 Signify Holding. All rights reserved. This document contains information relating to the product portfolio of Signify which information may be subject to change. No representation or warranty as to the accuracy or completeness of the information included herein is given and any liability for any action in reliance thereon is disclaimed. The information presented in this document is not intended as any commercial offer and does not form part of any quotation or contract. Philips and the Philips Shield Emblem are registered trademarks of Koninklijke Philips N.V.. All other trademarks are owned by Signify Holding or their respective owners. Signify Holding. The Netherlands
References
- Welcome | Philips lighting
- Driving connected lighting | Philips lighting
- Sustainable LED lighting solutions | Philips lighting
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>