OLIGHT Seemee 30 C Rear Light User Manual
- June 15, 2024
- OLIGHT
Table of Contents
OLIGHT Seemee 30 C Rear Light User Manual
IN THE BOX
SEEMEE 30 C
Type-C Cable
Rubber Ring
SPECIFICATIONS
**HIGHT
lumens
LOW
lumens
FLASH
lumens
ECO
lumens
SMART(DAY
lumens
SMART(NIGHT)
lumens
10cd
6m
IM
IPX6
22g/0.78oz
Working Temperature
-20°C-45°C
(L)65.5(W)25(H)22.5mm (L)2.58(W)0.98(H)0.89in
320mAh 3.7V (1.18Wh)
HOW TO INSTALL
BATTERY INDICATOR
When the light is on:
- The indicator flashes red when the battery power is less than 10%.
- The indicator does not light up when the battery power is above 10%.
When the light is off:
- Click the button to display the remaining battery level for 3 seconds.
Constant red
100%-11%:
Flashing red
10%-1%:
**HOW TO RECHARGE
** Standard charging time Approx. 2hrs (5V 500mA)
Charging Breathe
Fully Charged Power Indicator Off
DANGER
- DO NOT expose the device or batteries to fire, explosion, or other hazards.
- DO NOT disassemble or modify the light or any of the included items.
WARNING
- Keep out of reach of children.
- The light contains a polymer battery.
Certain restrictions may apply to this product when traveling, especially when traveling by air. Always check with your carrier for specific restrictions prior to traveling with this product.
NOTICE
- Store the light at room temperature in a dry place. Avoid moisture, or extreme hot or cold.
- Store the light in the charged condition. Avoid “deep discharge”. Battery life will decrease if the light is stored in a fully discharged condition.
- Over time, the run time of the battery will diminish. Expect about 500 full charges, depending on care. After a full life, the battery will continue to charge but with a lower run time.
OPERATING INSTRUCTIONS
ON/OFF: Press and hold the button to turn the light on/off, The default
output is the last selected brightness when turned off.
SMART MODE: The light sensor automatically adjusts the output brightness
according to the environment. The taillight will flash with 0-30LM during the
daytime and flash with 2-30LM at nighttime.
ADJUST BRIGHTNESS: When the light is on, single press the button to
change brightness level. The output brightness will cycle through Low High
Flash →ECO Smart Low…
MEMORY FUNCTION: When the light is turned on again, it will turn to the
last selected brightness level automatically.
LOW POWER MODE: When the remaining battery power is low, the switch
starts flashing and the lighting mode changes to ECO mode.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>