BEALE STREET AUDIO LS10G-BSC 10 Inch Down Firing Landscape Subwoofers Installation Guide

June 3, 2024
BEALE STREET AUDIO

LS10G-BSC and LS10B-BSC 10” Down-Firing
Landscape Subwoofers
Installation Guide

Introduction

Congratulations and thank you for purchasing the Beale Street Audio LS10G-BSC and LS10B-BSC 10” Down-Firing Landscape Subwoofers
The LS10G-BSC and LS10B-BSC 10” down-firing subwoofers are the perfect way to add low-end sound to your outdoor audio system. The compact design comes in 2 colors, black and green, making it easy to hide while providing exceptional bass response. The IP65 rating allows the sub to be weather and water resistant, making it an ideal solution for pools, patios, and gardens. A perfect pairing with the Beale Basics 4” and 6.5” Pendant Speakers with the optional landscape kit for a complete outdoor landscape system.

Features

10” Down-Firing Landscape Subwoofer – Green
LS10G-BSC

  • Weather and water-resistant landscape subwoofer designed to withstand sun, wind, and rain
  • Perfect for year-round outdoor use
  • Pair with Beale Basics 4” and 6.5” On-Wall/Pendant Speakers and WPV-LAND Landscape Kit for a complete outdoor landscape system
  • Woofer – 10” polypropylene cone
  • RMS Power – 150W
  • Frequency Response – 40Hz-300Hz
  • Nominal Impedance – 4 Ohm
  • Sensitivity – 86 dB
  • IP Level – IP65
  • Dimensions: 12.2” x 16.5” x 16.5” (310mm x 420mm x 420mm)

10” Down-Firing Landscape Subwoofer – Black
LS10B-BSC
Weather and water-resistant landscape subwoofer designed to withstand sun, wind, and rain
Perfect for year-round outdoor use
Pair with Beale Basics 4” and 6.5” On-Wall/Pendant Speakers and WPV-LAND Landscape Kit for a complete outdoor landscape system
Woofer – 10” polypropylene cone
RMS Power – 150W
Frequency Response – 40Hz-300Hz
Nominal Impedance – 4 Ohm
Sensitivity – 86 dB
IP Level – IP65
Dimensions: 12.2” x 16.5” x 16.5” (310mm x 420mm x 420mm)

What’s Inside?

LS10G-BSC LS10B-BSC

• LS10G-BSC Subwoofer
• 2 wire nuts
• 2 nail stakes
• Security eye bolt
• Product Manual| • LS10B-BSC Subwoofer
• 2 wire nuts
• 2 nail stakes
• Security eye bolt
• Product Manual

Connect and Operate

  1. Determine the location of the omnidirectional, down-firing subwoofer. Recommend installing the sub within 15ft of the any other landscape full-range speakers. Make sure that speaker wire is run to the location.

  2. OPTIONAL: Measure the center-to-center distance between the key-hole slots and install the two provided panhead nail stakes into the surface, leaving 1/4” of the screws exposed above the surface.
    NOTE: different types of surfaces and soil may require different stakes or mounting hardware that is sold separately.

  3. Connect the speaker wire run to the subwoofer location to the leads connected to the subwoofer with the provided wire nuts.

  4. OPTIONAL: For added security, use the provided security eyebolt to the bottom of the subwoofer and connect to a secure feature locally.

  5. OPTIONAL: If you plan utilized the nail stakes in step 2, place the subwoofer onto the pan head nail stakes and rotate the LS10B-BSC or LS10G-BSC clockwise so that the keyhole slots lock down onto the nail stakes.

Specifications

Description LS10G-BSC LS10B-BSC
Woofer 10″ Polypropylene Cone
Frequency Response  (+/-3dB) 40-300Hz
Impedance 4 ohm
Power Handling (RMS/PEAK) 150W/300W
Sensitivity 86dB
Colors Green Black
Rating IP65
Dimensions 12.2″x16.5″ (310x420mm)
Weight 24 lbs (10.9kg)

Limited Warranty
With the exceptions noted in the next paragraph, Vanco warrants to the original purchaser that the equipment it manufactures or sells will be free from defects in materials and workmanship for a period of two years from the date of purchase. Should this product, in Vanco’s opinion, prove defective within this warranty period, Vanco, at its option, will repair or replace this product without charge. Any defective parts replaced become the property of Vanco. This warranty does not apply to those products which have been damaged due to accident, unauthorized alterations, improper repair, modifications, inadequate maintenance and care, or use in any manner for which the product was not originally intended.
Items integrated into Vanco products that are made by other manufacturers, notably computer hard drives and liquid crystal display panels, are limited to the term of the warranty offered by the respective manufacturers. Such specific warranties are available upon request to Vanco. A surge protector, power conditioner unit, or an uninterruptible power supply must be installed in the electrical circuit to protect against power surges.
If repairs are needed during the warranty period, the purchaser will be required to provide a sales receipt/sales invoice or other acceptable proof of purchase to the seller of this equipment. The seller will then contact Vanco regarding warranty repair or replacement.
TECHNICAL SUPPORT
In case of problems, please contact Vanco Technical Support by dialing 1-800-626-6445.
You can also email technical support issues to [email protected]. When calling, please have the Model Number, Serial Number (affixed to the bottom of the unit) and Invoice available for reference during the call. Please read this Instruction Manual prior to calling or installing this unit, since it will familiarize you with the capabilities of this product and its proper installation. All active electronic products are 100% inspected and tested to insure highest product quality and trouble-free installation and operation. The testing process utilizes the types of high-definition sources and displays typically installed for entertainment and home theatre applications. For additional information please visit www.vanco1.com.
LIABILITY STATEMENT
Every effort has been made to ensure that this product is free of defects. The manufacturer of this product cannot be held liable for the use of this hardware or any direct or indirect consequential damages arising from its use. It is the responsibility of the user and installer of the hardware to check that it is suitable for their requirements and that it is installed correctly. All rights are reserved. No parts of this manual may be reproduced or transmitted by any form or means electronic or mechanical, including photocopying, recording or by any information storage or retrieval system without the written consent of the publisher. Manufacturer reserves the right to revise any of its hardware and software following its policy to modify and/or improve its products where necessary or desirable. This statement does not affect the legal rights of the user in any way.
The Vanco logo, Sonic Vortex logo, and Beale Street Audio Inc. logo are registered trademarks of Vanco International, LLC.
Vanco, Sonic Vortex, Beale Street Audio, Get Reale. Get Beale., the Vortex logo, and the Beale Street Audio logo are trademarks of Vanco International, LLC.

A BRAND FROM
Vanco International, LLC
506 Kingsland Drive
Batavia, IL 60510
Phone: 800.626.6445 Fax: 630.879.9189
www.vanco1.com
©2021

References

Read User Manual Online (PDF format)

Loading......

Download This Manual (PDF format)

Download this manual  >>

BEALE STREET AUDIO User Manuals

Related Manuals