ZANUSSI ZFV916Y 90cm Chimney Cooker Hood User Manual

ZANUSSI ZFV916Y 90cm Chimney Cooker Hood

VISIT OUR WEBSITE TO:
Get usage advice, brochures, trouble shooter, service and repair information: www.zanussi.com/support

SAFETY INFORMATION AND INSTALLATION

WARNING!
carefully the Safety chapters before any use or maintenance of the appliance.

Refer to the separate Installation Instructions booklet for Safety Information and Installation. Read

PRODUCT DESCRIPTION

CONTROL PANEL OVERVIEW

1. On / Off
2. First motor speed
3. Second motor speed
4. Third motor speed
5. Maximum motor speed
6. Breeze function
7. Filter reminder
8. Hob to Hood function
9. Lamp

DAILY USE

USING THE HOOD

Check the recommended speed according to the table below.

1. While heating up food, cooking with covered pots.
2. While cooking with covered pots on multiple cooking zones or burners, gentle frying.
3. While boiling and frying big quantities of food without a lid, cooking on multiple cooking zones or burners.
4. While boiling and frying big quantities of food without a lid, big humidity.
5. Refreshes the air in kitchen after cooking at a very low noise level. It can be activated and de-activated by touching the symbol. The function turns off automatically after 60 minutes. Use after cooking only.

It is recommended to leave the hood operating for approximately 15 minutes after cooking.
The control Panel is a sensor field. Touch the symbols for 1 second to activate the functions.

To operate the hood:

1. Turn on the appliance by pressing the symbol.
   You can now activate the functions.

2. To activate the function touch the symbol.

3. If needed, touch the light symbol to illuminate the cooking surface. To turn off the appliance press the again.

HOB TO HOOD FUNCTION

It is an automatic function which connects the hob with a hood. Both the hob and the hood have an infrared signal communicator. Speed of the fan is defined automatically on basis of mode setting and temperature of the hottest cookware on the hob. You can also operate the fan using the hob manually. The function can be activated from panel of the hob.

For more information how to use the function refer to the hob user manual.

ACTIVATING MAXIMUM MOTOR SPEED
When you press the button , the Maximum Motor Speed starts to operate for 8 minutes. After

CARE AND CLEANING

CLEANING THE GREASE FILTER

Each filter must be cleaned at least once a month. Filters are mounted with the use of clips and pins on the opposite side.
To clean the filter:

1.  Pull the cover to open it.
   that time, the appliance returns to its previous speed settings.
   When the function is turned on, additional touch on the button does not have any effects.
   ACTIVATING AND DEACTIVATING THE FILTER NOTIFICATION
   Filter alarm reminds to change or clean the charcoal filter and clean the grease filter. The filter indicator is turned on (white) for 30 seconds if the grease filter must be cleaned. The filter indicator flashes (white) for 30 seconds if the charcoal filter must be replaced or cleaned.
   Refer to filter alarm in care and cleaning chapter.

2. Switch on the control panel.

3. Make sure that the icons are turned off.

4. To activate or deactivate the charcoal filter notification touch for 3 seconds.
   If the charcoal filter notification is activated, the filter icon flashes (white) five times.
   If the charcoal filter notification is deactivated, the filter icon flashes (white) three times.

5. Press the handle of the mounting clip on the filter panel underneath the hood (1).

6. Slightly tilt the front of the filter downwards (2), then pull.
   Repeat the first two steps for all filters.

7. Clean the filters using a sponge with non abrasive detergents or in a dishwasher.
   The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolor, it has no influence on the performance of the appliance.

8. To mount the filters back follow the first two steps in reverse order.
   Repeat the steps for all filters if applicable.

REPLACING THE CHARCOAL FILTER

WARNING! The charcoal filter is non-washable!

The time of saturation of the charcoal filter varies depending on the type of cooking and the regularity of cleaning the grease filter.

To replace the filter:

1. Remove the grease filters from the appliance. Refer to “Cleaning the grease filter” in this chapter.
2. To install a new filter, perform the same steps in reverse order.
   In any case, it is necessary to replace the filters at least every four months.

REPLACING THE CHARCOAL FILTER
The charcoal filter must be replaced if the filter alarm is on.
Refer to the filter alarm in this chapter.

The time of saturation of the charcoal filter varies depending on the type of cooking and the regularity of cleaning the grease filter.
WARNING! The charcoal filter is NON-washable! The filter cannot be regenerated!

To replace the charcoal filter:

1. Remove the grease filters from the appliance. Refer to “Cleaning the grease filter” in this chapter.
2. Turn the filter counterclockwise (1) and then pull (2).
   

To mount the filters back follow the steps in reverse order.

FILTER ALARM

• Refer to activating and deactivating the filter alarm in daily use chapter.
• Refer to cleaning the grease filter in this chapter.
• Refer to cleaning the charcoal filter or replacing the charcoal filter (depends on filter type).

To reset the alarm:
Touch the for 3 seconds.

REPLACING THE LAMP
This appliance is supplied with a LED lamp. This part can be replaced by a technician only. In case of any malfunction refer to “Service” in the “Safety
Instructions” chapter.

ENVIRONMENTAL CONCERNS

Recycle materials with the symbol . Put the packaging in relevant containers to recycle it. Help protect the environment and human health by recycling waste of electrical and electronic appliances. Do not dispose of appliances marked with the symbol with the household waste.
Return the product to your local recycling facility or contact your municipal office.

References

• Zanussi - Zanussi.com

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>