Riva RND-RV5096 Chrome Towel Rail 500mm x 960mm Installation Guide
- June 3, 2024
- Riva
Table of Contents
Riva RND-RV5096 Chrome Towel Rail 500mm x 960mm
RIVA INSTALLATION GUIDE
This product must be fitted only by a fully qualified installer.
- The radiator should not be mounted closer than 50mm below arry overhanging surface A (Lei shelf) and no lower than 100mm from the floor. Transfer the bracket drill position measurements to the wall.
- Drill the wall and insert wall B anchors (1)(or other suitable Filings)
- Put the brackets (2) on the wall and screw them to the wall anchors (1) with fixing screws (5) and washers (4).
- Screw the brackets (6) onto the nuts welded on the back of the radiator.
- Insert brackets (6) in to the E brackets (2) and tighten the security screws (3).
GENERAL RECOMMENDATION
- Before fitting the radiator it is necessary to wash out the heating system to remove any existing mud, scale, work residues, traces of flux, oil, etc.
- When the system water pH is outside the 5,5-8,5 range and/or when the dissolved is above 0,1mg/liter, it is always needed to protect the heating system components (the radiator is one of these) with a proper chemical treatment compatible with all parts in contact with water (silicon rubber too).
- in order to fit the radiator to the wall, it is necessary to choose the proper fixings for the wall material. if the system water exceeds s0’C, please install a warning mark near the radiator to avoid any accidental scalding.
- Clean the radiator surface only with a soft cloth to avoid scratching the finish and do not use chemical agents during cleaning operations. It is prohibited to climb on the radiator
- Maximum working temperature 95C, maximum working pressure 4 bar.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>