DEATSCHWERKS 04-7 Impreza STi DW200/300 Fuel Pump Installation Guide

June 3, 2024
Deatschwerks

DEATSCHWERKS 04-7 Impreza STi DW200/300 Fuel Pump Installation Guide
DEATSCHWERKS 04-7 Impreza STi DW200/300 Fuel Pump

Parts List

  • DW200/300
  • Fuel Hose
  • Hose Clamps (x2)
  • Fuel Sock
  • 6” Electrical Connector
  • Fuel Pump Isolator

Parts List

Installation Instructions

PLEASE READ – this guide is intended to aid in the installation of our products. It is recommended that factory manuals or instructions are followed to remove the fuel pump assembly from the vehicle. Some instructions in this guide are generic. The factory manual should supersede any contradiction.

Below is a picture of suggested tools that will make the installation process easier.

Installation Instructions

Installation Instructions

  1. remove the fuel sock cover from the base of the assembly
    Installation Instructions

  2. oosen the hose clamps and push them up the hose toward the top, then pull the pump out of the assembly. Disconnect the electrical connector from the pump
    Installation Instructions

  3. prep the DW300 by installing the fuel sock and retainer. Start installation of the retainer by pressing it on with your thumb, then use a 4-5mm deep socket to press it on the rest of the way
    Installation Instructions

  4. measure and cut the supplied hose, then install it onto the assembly inlet. Slide the new hose clamps on the hose toward the top of the assembly and install the DW200/300 with the supplied isolator on the bottom of the pump. The supplied electrical connector is for earlier Impreza models that came with a different pump connector design. The OE connector can be retained
    Installation Instructions
    Installation Instructions

  5. install the top of the fuel sock cover first (white piece)
    Installation Instructions

  6. install the bottom of the fuel sock cover (black) by clicking into place
    Installation Instructions

  7. reinstall the assembly into the fuel tank and attach a length of hose to the outlet of the pump assembly allowing it to drain into a fuel safe container and prime the fuel pump assembly

  8. cycle the key to the on position as many times as required to prime the pump assembly and evacuate the air introduced during the pump installation process

  9. attach supply line to the outlet of the pump assembly

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals