DEATSCHWERKS DW300 Fuel Pump Installation Guide
- June 13, 2024
- Deatschwerks
Table of Contents
DEATSCHWERKS DW300 Fuel Pump
Product Information: Universal DW200/300 Fuel Pump
The Universal DW200/300 Fuel Pump is a high-performance fuel pump designed for universal fitment in vehicles manufactured between 1980 and 2000. It is manufactured by DeatschWerks, a leading provider of fuel system components.
Parts List:
- Universal DW200/300 Fuel Pump
- Universal Metal Hanger
Features:
- High-performance fuel pump
- Designed for universal fitment
- Suitable for vehicles manufactured between 1980 and 2000
Product Usage Instructions: Universal DW200/300 Fuel Pump Installation
Step 1: Gather the necessary tools
Before starting the installation process, make sure you have the following
tools:
Step 2: Preparing for installation
Ensure that you have all the necessary parts from the parts list.
Step 3: Installation process
- Locate the fuel pump in your vehicle.
- Remove the old fuel pump carefully.
- Attach the Universal DW200/300 Fuel Pump to the universal metal hanger.
- Install the fuel pump assembly into the designated location in your vehicle.
- Connect the fuel pump’s electrical connector to the vehicle’s wiring harness. If required, solder the connector and cover it with fuel-resistant tape for added protection.
- Ensure all connections are secure and properly tightened.
Note: The installation process may vary depending on your specific vehicle. Refer to your vehicle’s user manual or consult a professional if you encounter any difficulties during the installation.
For additional information or troubleshooting, please refer to the complete Universal DW200/300 Fuel Pump Installation Guide provided by DeatschWerks.
DeatschWerks
Universal DW200/300 Fuel Pump Installation Guide 9-201/301/421/421S-1000
Universal 1980-2000 DW200/300 Fuel Pump Installation Guide
Parts List
- DW200/300
- Fuel Sock w/ Retainer Clip
- 3” Submersible Fuel Injection Hose
DeatschWerks
Universal DW200/300 Fuel Pump Installation Guide
- 5/16” Hose Clamps (x2)
- Electrical Connector w/ Leads
DeatschWerks
Universal DW200/300 Fuel Pump Installation Guide
Universal Metal Hanger DW200/300 Fuel Pump Install
PLEASE READ – this guide is intended to aid in the installation of our
products. It is recommended that factory manuals or instructions are followed
to remove the fuel pump assembly from the vehicle. Instructions in this guide
are generic and are intended to aid in the installation of a DW200/300 pump in
the typical 1980-2000 metal fuel pump hanger. The factory manual should
supersede any contradiction.
Below is a picture of suggested tools that will make the installation process
easier.
DeatschWerks
Universal DW200/300 Fuel Pump Installation Guide
-
separate the pump from the assembly, use caution when removing connectors and clips and inspect the wiring and soft components condition for consideration of reuse.
-
prep the DW pump with components from the universal installation kit and reusable OE components.
-
if applicable, splice the OE connector with the electrical connector from the installation kit.
NOTE: in this example, the connector was soldered together and covered with fuel resistant tape. Covered (fuel safe) connectors can also be used. -
install the DW pump and plug in the connector
-
reinstall the assembly into the fuel tank and attach a length of hose to the outlet of the pump assembly allowing it to drain into a fuel safe container and prime the fuel pump assembly
-
cycle the key to the on position as many times as required to prime the pump assembly and evacuate the air introduced during the pump installation process
-
attach supply line to the outlet of the pump assembly
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>