Razor W13113202032 Power A5 Quick Release/Stem Replacement Instructions
- June 3, 2024
- Razor
Table of Contents
Razor W13113202032 Power A5 Quick Release/Stem Replacement Instructions
Required Tools: (Not included)
- Phillips screwdriver
- Small Flat screwdriver
- Long needle nose pliers
- 3 mm Allen wrench
- 5 mm Allen wrench
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before conducting any assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
Assembly Instructions
-
Step 1
Using a Phillips screwdriver, remove the screw located at the very front of the deck and pull the deck cover off from the deck.
-
Step 2
Disconnect the throttle cable from the controller. -
Step 3
Using a small flat screwdriver, remove the grommet inside the opening of the deck. -
Step 4
Unfold the unit. Using a pair of long needle nose pliers, remove the spring from the folding mechanism pin.
-
Step 5
Using a smal flat screwdriver, remove the C ring from the folding mechanism pin. Slide the pin out from the frame.
-
Step 6
Using a 3 mm Allen wrench, remove the set screw at the back of the folding knob while holding the knob. -
Step 7
Unscrew and remove the knob. Slide down the plastic block of the folding mechanism. -
Step 8
Set aside all the parts from the folding mechanism.
-
Step 9
Using a 5 mm Allen wrench, loosen the bolt from the collar clamp and remove the stem from the fork.
-
Step 10
Open the quick release. -
Step 11
Using a 3 mm Allen wrench, loosen the screw from the quick release. -
Step 12
Slide the quick release up from the stem and replace it.
-
Step 13
Reverse the steps.
ATTENTION: Charge battery 10 hours before using.
Support
Need Help?
Visit our website at
www.razor.com or
call toll-free at 866-467-2967
Monday – Friday 8:00am – 5:00pm Pacific Time.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>