TOUGHTESTED TT-PBHW-GN Hand Warmer and Phone Charger User Guide
- June 3, 2024
- TOUGHTESTED
Table of Contents
TOUGHTESTED TT-PBHW-GN Hand Warmer and Phone Charger
PRODUCT DIAGRAM
- LEDs
- USB port
- Micro USB port
- Power button
CHARGING THE POWERBANK
- Before first use fully charge the powerbank
- Connect the included micro USB cable into the micro USB port on the powerbank
- Connect the other end of the cable to a USB power source such as a wall or car charger
- The LEDs on the front of the powerbank will light up while it is being recharged
- When all 3 LEDs are lit the powerbank is fully charged
CHARGING A SMARTPHONE
- Connect a USB cable between the powerbank and your device
- Press the power button to turn the powerbank on, the LEDs will show as blue
- The LEDs will stay on while your phone is charging
- When your phone is charged the LEDs will turn off
Note: You can charge a Smartphone or other USB device while the powerbank is being recharged.
CHECKING THE BATTERY LEVEL OF THE POWERBANK
- Press the power button, the LEDs will turn on to indicate the charge level
- One LED on < 30% power remains, Two LEDs on 30% to 70%, 3 LEDs on 70% to 100% · The LEDs will automatically turn off after 35 seconds when there is no device being charged · You can also short press the power button twice to turn it off
USING THE HAND WARMER FUNCTION
- Press and hold the power button for 2 seconds to start heating mode
- The LEDs will be red in heating mode
- The Hand warmer will be in high mode to start, press the button again to go to medium heat, press again to go to low heat · To exit heating mode, short press the power button 2 times.
PRODUCT SPECIFICATIONS
| Input (Micro USB port): | 5V/1A (5 watts) |
|---|---|
| Output (USB port): | 5V/1A (5 watts) |
| Battery: | 3600mAh (13.32Wh) lithium-ion battery |
| Working temperature: | 0-50C (32-122F) |
| Cable length: | 30cm (12 inches) |
| Hand warmer run times: | 9hrs @ 95F (35C), 5hrs @ 104F (40C), 3hrs @ (50C) |
SAFETY INSTRUCTIONS
- Do not use the hand warmer heating function when the powerbank is being recharged
- Do not place near a heat source like a radiator or other heat producing devices
- Do not place in direct sunlight or in places with high temperature
- Do not expose the device to water, moisture, or high humidity
- Do not throw batteries in the garbage, contact your local recycling center for proper disposal
- Do not open the device, there are no user serviceable parts
- Store in a cool dry place when not in use
FCC STATEMENT:
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/ TV technician for help. This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation. CAUTION:
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment ICES This Class B digital apparatus complies with Canadian ICES-003.
LIMITED WARRANTY
Thank you for purchasing a ToughTested® product from Mizco international, Inc.
We want you to enjoy this product without any problems. However, in the
unlikely event that it malfunctions, we will either repair or replace it as
part of the product’s 5 year limited warranty.
If the product has malfunctioned during normal use, the responsibility of
ToughTested® is limited solely to the repair or replacement, at its option, of
the product. This warranty does not extend to damage or failure that results
from misuse, neglect, accidents, alteration, abuse, improper installation or
maintenance.
All brands represented herein are registered trademarks of their respective
manufacturers. Design and specifications are subject to change without notice.
©Mizco International, Inc. All rights reserved. All trade names are registered
trademarks of the respective manufacturers listed. Mizco International Inc.,
Cranford, NJ 07016 techsupport@mizco.com
www.mizco.com
www.toughtested.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>