Cabelcon TL212 TrueLock Connector Instruction Manual
- June 3, 2024
- Cabelcon
Table of Contents
Mounting Instruction for TrueLock Connector Type TL212
TL212 TrueLock Connector
Step: 1
Use Cabelcon´s Dualstrip tool (item no. 28021275 for welded cupper cables) for
proper preparation of the cable.
Please read the enclosed user instruction before operation the tool.
After completed strip operation, the prepared cable dimension should be as
following:
A = 11,0mm
B = 8,0mm
If necessary, clean the cable inner conductor with a conductor cleaner item
no. 98500903 and the outer conductor with appropriate equipment.
Step: 2
Place the back nut over the cable and push it back ward to reach mechanical
stop.
Step: 3
Push the front end of the connector and the back nut (with cable) together by
hand. During this step, the cable´s inner conductor slips into the center
seizing mechanism of the connector front part.
Step 4:
Tighten the back nut by hand as far as possible. Then use two open ended
spanners to further tighten the back nut to mechanical stop.
The connector body must be kept in place during the tightening.
| Tools and Accessories | Item No. |
|---|---|
| DUALSTRIP TOOL –TL212/-TL243 | 28021275 |
| GROUNDING RING TYPE 2 | 98028562 |
| CABLE CUTTER TRUNK 25.4mm | 98028623 |
| CONDUCTOR CLEANER CC-200EUR | 98500903 |
| TORQUE WRENCH HEX 22mm 9.0NM (for 3,5/12M interface) | 98029110 |
| TORQUE WRENCH HEX 14mm 4.5NM (for FM interface) | 98029095 |
| TORQUE WRENCH HEX 15mm 4.5NM (for IEC14M interface) | 98029098 |
Amphenol Cabelcon ApS
Industriparken 10, DK-4760 Vordingborg
www.cabelcon.com
cccustomercare@cabelcon.com
Rev. Date: 11/01-2022
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>