TOPDON ArtiLink 600 Diagnostic Scanner User Guide
- June 3, 2024
- TOPDON
Table of Contents
TOPDON ArtiLink 600 Diagnostic Scanner
Overview
- Diagnostic Cable with LED
- DB-15 Diagnostic Connector
- USB Port
- TF Card Slot
- Erase DTC Shortcut
- I/M Shortcut
- EXIT Button
- OK Button
- Selection Button
- Help Buttons
- Read OTC Shortcut
- LED for Different DTCs
- LCD Screen
Preparation
- The ignition is turned on
- The vehicle battery voltage is 9~ 18 volts.
- The throttle is in the closed position.
Start Diagnostics
- Locate the vehicle’s DLC port for the OBDII connection
- Connect Artilink600’s OBDI I cable to the vehicle’s DLC port. Artilink600 will power on automatically, and be ready to use
Register & Upgrade
The registration and upgrade is not necessary procedure for Artilink600’s normal use.
- Go to https://www.topdon.com/products/artilink600 to download, decompress and install TOPDON Update Tool on Windows XP, 7, 8 & 10.
- Connect Artilink600 to the computer via the USB cable. Enter main menu ->HELP -> Tool Information to get the Serial Number and Register code for later use. Disconnect Artilink600.
- Remove the TF card in ArtiLink600. Insert the supplied adaptor with the TF card into the USB port of the computer.
- Run the TOP DON Update Tool. Follow the prompts, and input the information required to finish the registration. Click Submit.
- Select the updates you desire, and download the update package into the memory card.
- Insert the TF card with the downloaded update package into ArtiLink600.
- Power up Artilink600 via the USB cable. Artilink600 will automatically start updating if a newer version is detected in the memory card.
IMPORTANT: Read the instruction carefully before operating. Failure to do so may cause damage and/or personal injury.
NOTE: This Quick Start Guide is subject to change without written notice.
IF YOU HAVE QUESTIONS OR COMMENTS, CONTACT US.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>