SAFEWAZE Material Winch Bracket Instructions
- September 28, 2024
- SAFEWAZE
Table of Contents
Material Winch Bracket
“`html
Product Specifications:
- Model: Material Winch Bracket
- Manufacturer: Safewaze
- Bracket Part Number: 024-11049
- Fastener Size: M10 x 1.5mm
- Torque Range: 45-50 Nm
Product Usage Instructions:
-
Order New Bracket: Purchase the new device
bracket (024-11049) which includes the bracket and fasteners. -
Remove Existing Bracket: Remove the current
fasteners and bracket from the Material Winch. Apply force if
needed, especially if Loctite is present on original bolts. -
Align New Bracket: Align the new bracket onto
the device according to the provided instructions. -
Install Fasteners: Reinsert new fasteners
following the specific order. Inside requires a flat washer and
bolt, while outside needs a flat washer, split lock washer, and
nyloc nut. -
Torque Bolts: Torque the bolts to 45-50 Nm
using two wrenches to tighten from both inside and outside. Avoid
over-torquing.
Refer to the Safewaze manual provided with the product or
available online for proper use and additional installation
information. For any questions, contact Customer Service at (800)
230-0319.
Frequently Asked Questions (FAQ):
Q: Can I use the old bracket with Xtirpa systems?
A: No, the old bracket is not compatible with Xtirpa systems.
You need to order the new device bracket (024-11049) for
compatibility.
Q: What should I do if I encounter difficulties during
installation?
A: If you face any challenges during installation, refer to the
provided instructions carefully or contact Customer Service for
assistance.
Q: Is it necessary to apply Loctite when reinstalling the
fasteners?
A: It is not required to apply Loctite when reinstalling the
fasteners, but you may encounter resistance if it was used on the
original bolts.
“`
MATERIAL WINCH BRACKET UPDATE INSTRUCTIONS
Safewaze has redesigned the device bracket of the Material Winch to
accommodate Xtirpa systems.
In order to retrofit an existing device in the field, please follow these
instructions:
1. Order the new device bracket (024-11049, bracket and fasteners included).
2. Remove current fasteners and bracket from Material Winch. This may require
some force if Loctite is present on original bolts.
3. Align the new bracket onto the device as shown.
4. Reinsert new fasteners as shown. For the inside, a flat washer and then
bolt. For the outside, a flat washer, split lock washer, and then nyloc nut.
5. Torque bolts to 45-50 Nm. Installer will need 2 wrenches to tighten bolts
from both the inside and outside. Be careful not to over-torque.
024-11049 Fasteners: (2) M10 x 1.5mm Bolts
Outside Fastener Installation
Detent Pin for Installation to Mounting Bracket
(4) Flat Washers
(2) Split Lock Washers
(2) Nyloc Nuts
Inside Fastener Installation
New Device Bracket
Refer to the Safewaze manual provided with the product, or available online,
for proper use and additional installation information.
For any questions regarding the information in this Instruction Sheet, please
contact Customer Service at
800-230-0319.
220-00129: V1
225 Wilshire Avenue SW, Concord NC · 800-230-0319 · safewaze.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>